R52 Annoying Seatbelt thing...
#1
Annoying Seatbelt thing...
My driver's side seat belt seems to have the male end on backwards. When you pull it over your shoulder to secure it, you always have to twist it to go into the receiver correctly. The belt would lie flat if the male end were on 180 degrees from where it is now. Anyone have this? I know it is minor but, it is annoying. Any ideas or suggestions?
Thanks,
Paul
Thanks,
Paul
#2
#3
#4
6th Gear
iTrader: (5)
Join Date: Oct 2005
Location: Southeast Missouri
Posts: 2,313
Likes: 0
Received 0 Likes
on
0 Posts
I have the same problem with the backseat drivers side belt. It seems the more I try to fix it, the worse it gets. I figure it is from driving with the top down a lot, and the wind is twisting the belt. I have finally decided I don't ride in the back, so I'm not going to worry about it.
#7
Trending Topics
#8
Oettpo - pull your belt all the way out and see which way it is twisted. Fold it over the other way and put it through the slot. It should work out okay then.
Does anyone else have a problem with the buckle sticking in the latch during ejection? Mine comes out halfway and gets stuck approx. 1 in 10 times, i'm worried what might happen in an emergency, but since i can't get it to happen on command, i haven't told the dealer...
Does anyone else have a problem with the buckle sticking in the latch during ejection? Mine comes out halfway and gets stuck approx. 1 in 10 times, i'm worried what might happen in an emergency, but since i can't get it to happen on command, i haven't told the dealer...
Thread
Thread Starter
Forum
Replies
Last Post
ECSTuning
Vendor Announcements
0
10-01-2015 12:13 PM