done.

 

Does anyone know the valve size of RMW heads? I tried to e-mail them but no reply??

 

Here is the "final" list. We have the 10 guaranteed cars and 4 wait list people. If we go over into Sunday, these 4 have expressed great interest in getting tuned also, so we will minimize dyno costs as much as possible!

7:30 nparker [Sunshine MINIs]
8:30 littlehandegan
9:30 Tampa MCS
10:30 cartar452 - nitrous

1:00 stppon43 [Sunshine MINIs] - twincharge
3:00 Ingsoc
4:00 TReed [Sunshine MINIs]
5:00 Silkworm
6:00 Cabmeister [Sunshine MINIs]
7:00 sknandigam [Sunshine MINIs]

Wait List:
Trackownus Maximus [Sunshine MINIs]
Jazz042 [Sunshine MINIs]
1fastmini [Sunshine MINIs]
JBKone [Sunshine MINIs]

 

got my parts for install by the dyno shop on friday and then ill be there probably early just to bs with you guys.

So for the tune ill have:
-JCW injectors
-15%
-Alta intake
-lighter stock size crank
-Miltek full exhaust with soon to be welded in magnaflow
-2 new O2 sensors
-DT BPV

On a side note I just installed some magnecor 8mm race Sparkplug wires and they really smoothed out my power delivery i had stock cables on but they were trash when i removed em the cable popped off of the part that conects to the spark plug. So if anything i recouped lost power from the stockers. I also have the MSD coil.

 

Leaving in an hour woot woot! ill post my dyno sheet today in a new thread

 

Curious to see what kind of gains you guys saw with your tune??? My belt kept slipping in the high RPM range so I only saw a 10 hp gain. Purchased the smaller belt yesterday and will be putting it on this week. Should be around 190hp then with a pulley, intake, exhaust and RMW tune.

 

I made 189 with 15%, one-ball, HAI, and 380s. 9 hp gain. The weather I had during my session must have contributed, seeing as though is was 7-10 degrees cooler at night.