Help with limp mode
Thread Starter
|
1st Gear
Joined: Jan 2011
Posts: 45
Likes: 0
Help with limp mode
I have changed the spark plugs I have changed the oil I have changed the Vanos Solenoid and I have change the camshaft sensors. If my car is cold when I started it goes into limp mode until I turn off the code but if it's hot no limp mode I need help what else should I try
6th Gear
Joined: May 2018
Posts: 1,361
Likes: 246
From: Washington state
From what I can find, it looks like that is a code for cold start fuel pressure. There is a good chance that your HPFP (high pressure fuel pump) is starting to go, it’s a known issue on these. Depending on your mileage, you may very well be covered by a warranty extension from MINIUSA for it. If so, a huge plus! They have extended it out to 100,000 or 120,000 miles.
Go on the website for Miniusa and there is a section where you can enter your VIN and it will tell you which warranty extensions you are covered for.
Go on the website for Miniusa and there is a section where you can enter your VIN and it will tell you which warranty extensions you are covered for.
Thread
Thread Starter
Forum
Replies
Last Post
Jonny Crisp
Stock Problems/Issues
9
Mar 31, 2017 10:57 AM
Drivetrain Help my car went into limp mode! What to do?
Eriko
Drivetrain (Cooper S)
2
Mar 29, 2007 03:50 PM
