Does anyone have a good how-to showing how the rear side panels (carpeted all the way in the boot) come out? I want to mount a processor where the OEM amp would go but I don't want to chance breaking anything since it's less than 10 degrees over here.

Thanks all.

 

Winter is a pain to do this kind of work.

Hope this hleps

1. Remove C-Pillar covers (pop out "airbag" cover, small oval at top and remove torx screw)
then follow these instructions.

https://www.northamericanmotoring.co...nel-remove.pdf

 

The link is broken. :( What gallery is it in? I looked in yours but didn't see it.

Thanks,
Paul

If it won't load here would you be able to email it to me? My email address is in my profile or I can PM it to you.

 

Strange the link works for me. but PM me you e-mail address and i will send it out. E-mail address do not show on the PUBLIC profile normally and i did not see it listed there.

 

All I get is "Page not found". Weird.

PM sent. Thanks!

 

Can anyone else see the document in the link? I'm stuck and I need to get this done today.

Thanks!

 

I know it's a touch late, but nope. Can't access the link either. Seems dead.

 

It's early for me. I'm 6 hours ahead so it's just the start of my day.

 

Page not found, is what I get.

 

Anyone else know of a how-to or anything? I'm pretty sure the only thing still holding it in is the floor support rail but I can't figure out how it comes offto save my life.

Thanks all

 

quality, i just sent you the e-mail with the instructions. But the plastic rails that the flat floor hooks into and sits on just pull off. They are hard to get off the first time may need a large plastic scraper behind them to force them off.

 

Yeah, I felt all kinds of silly when I saw your .pdf but I guess it's better to know than to guess and break something. Thanks again.

Cheers!
Paul

 

Updated the link not sure why it was not working on others computers but it was working on mine at home and at work. Can someone check it.

 

It works for me now.

Thanks!