When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Category: Suspension Price: $5555 Private or Vendor Listing: Private Listing Part fits (you may select multiples): R55, R56, R57, R58, R59, R60 Location (Region): SouthEast Item Condition: Used
Car is going back to stock, I've started pulling parts off and will update as items are removed. Prefer local sales but will ship - ALL SHIPPED PRICES ARE CON US, So far I have out:
SOLD!$700 shipped - Quaife QDF38Z Limited Slip differential. been installed for about a year, about 5k miles. timken bearings pressed on the ends. will include the shells as i didnt bother to have them pressed out/in the case. https://www.waymotorworks.com/quaife...ferential.html
$650 Shipped - Alta 3" Downpipe Back exhaust - On car for about 2 years, Vband clamps have been swapped (included clamps were trash) ones a vibrant quick release - the other a ticon. OEM clamp worked the best connecting to down pipe. Front hangers had to be cut off and welded back in the correct place - I will probably clean them up and put a nice coat of high temp paint on it. Has been on car problem free, Tips clean up easily. Will make a good deal if local, really dont want to ship http://altaperformance.com/i-1400713...bo-engine.html
$400 shipped (since it seems the price of these has come down) - N18 2010-12 High Pressure Fuel Pump. Bought from ECS tuning Jan/2017, genuine MINI. Was troubleshooting some issues with my car (out of extended warranty) bought another one only to find out it wasn't the problem. So now i have two that work fine, less than 5k miles. https://www.ecstuning.com/b-genuine-...e/13517592429/
SOLD!$60 shipped - Integral Audio X9331 T-harness. provides 2 sets of RCA outputs, installs behind driverside kick panel. pretty sure integral audio is no longer making these - caught last limited run of them made https://www.northamericanmotoring.co...available.html
SOLD!165 +shipping - Hotchkis H-sport Comp 25.5mm rear sway bar. Been on car a little over a year, only set in the third position. Has rubbed in a few places - noticed after taking off, never any noise out of it. bought from WMW https://www.waymotorworks.com/h-spor...-sway-bar.html
SOLD!175 +shipping - Hotchkis H-sport rear camber links. On car for a little over a year. One is pretty clean, the other has a few wrench marks on the adjusting link. bought from WMW. picture shows 1 90* grease zerk broke i will replace it https://www.waymotorworks.com/h-spor...ber-links.html
SOLD! 950+Shipping - Howerton Aquamist HFS-4 V3.1 with 1gal tank for R56. On car for about 6 months, only used VP racing fuels meth and distilled water through it. red led gauge, all connectors perfect, no cables shortened when i installed so plenty of length for any mini. gauge is mounted in craven speed vent pod will include if wanted. The PTFE pipe is very inexpensive. I can include what i have but I would probably replace it with new for piece of mind 6mm from pump to FAV, 4mm from FAV to jet. Only thing not included is a few misc positaps and ring terminals. has .8,.9,1.0 jets, 4mm check valve, 90* fitting for 4mm tubing, i think i have an extra jet adapter and plug, HFS4 manual, howerton instructions. If local I have little bit of meth left I'll throw in. http://howertonengineering.com/produ...kit-with-tank/ https://www.cravenspeed.com/mini-ven...xoCB5MQAvD_BwE
Other stuff that will be for sale when i get around to removing:
SOLD! Megan Coilovers, a little over a year old, only ran with about 1.5" drop. Soon as i pull the front and make sure all is good. maybe $450?
Ebay intercooler, dont really remember what i paid. fits good, no issues, ran 20+ psi thru it for over a year. maybe $125? I'll throw in the alta muffler delete pipe (red)
Turbosmart full recirc valve- TS-0203-1252 used for a few months comes with boost adapt, some lines, resistor for stock electrical connector. $150
Milltek Downpipe , catless $150?
If anyones interested in the gpop hybrid turbo? has about 15k miles, no shaft play - big + if you have a stock turbo somewhat working to swap+cash
and if turbo gets sold and i'm that far into it i have the WMW/JCW manifold I can pull it off also.
Driverside axle, for manual car- genuine mini, maybe 3k miles, ended up with an extra one of these also. car developed the acceleration wobble, figured it was going out so i bought a new one. When i went to replace it, the one in there wasn't even seated in the transmission, i swapped them and pulled a boot on the old one anyway to inspect. New one just has a pry mark or two on the transmission side to get the clip out. 350?
If it's for the R56, can you shoot me over photos of the intercooler and alta hotside boost pipe? I need that.
Is it the full TS-0203-1252 kit or is anything missing? I will take that too.
I will pull the IC and tube this afternoon if i get home early enough.
The turbosmart, I should have everything for it minus the smaller fitting that threads into the boost adapter for a separate boost gauge (do not have one so adapter has larger fitting and plug in other port). i will look for it though, and i will throw in some new tyraps https://c1552172.ssl.cf0.rackcdn.com/884417_x600.jpg
I am semi- interested in the gpop turbo. how much were you thinking cash plus stock turbo. Mine has no shaft play at all. Runs perfect.
Again I will gladly keep you first in line, but I would like to remove, give it a good once over before selling.
Gpop rebuild was $780+ turbo, manifold is $450
Let's call it:
$700 turbo+manifold
$500 turbo
$500 turbo+manifold+working turbo core
$325 turbo+working turbo core
SOLD!450+shipping- , Coilovers out and cleaned up a little bit, all the top mounts are still tight, also have the adjustment wrenches and dampening extensions for the rear.
Intercooler and turbo muffler delete pipe - both are pretty rough. If someone really wants them make offer. both functional $125 obo
Intercooler has cast aluminum ends, rolled beads on the in/out, side tabs line up with stock mounts, on my car the top tab didnt hit anything and wasnt used. At some point it looks like it took a pretty nice shot from something on the road, has a patch of the fins laid over- prob about an inch long on one row, 1/2 inch long on the row under it.
Pipe, has a few issues. where it connects to the turbo the inside silcone is coming off a few small spots about 3/4" in, the groove on the compressor discharge is about 1-1/4 in, so i doubt it will really effect anything. I used a tclamp instead of a hose clamp on it, probably put a little to much pressure. small slit on the outside not deep, a little chunk out of the pipe about half way down maybe 1/4" long, through 1st layer of silicon - pipe is 5ply thick