Interior/Exterior Any R53s with R50 skirts?
#2
#5
Don't sweat the pics, nabeshin...I got a few from Rick aka not-so-darksilvernwhite-or-rednwhite-but-electricbluenblackcooper over on my MU thread...
http://www.motoringunderground.com/f...ad.php?t=15495
http://www.motoringunderground.com/f...ad.php?t=15495
#6
#7
Trending Topics
#8
Not hard at all, you will need new clips and new door sills as they are nearly impossible to remove without bending them.
and R53 bumper
and R53 bumper
#9
ha! i never knew there was a difference in R50 sideskirts....but I still like my R53 better...but at least i know there are clientel out there for when i get my aero skirts and sell off the R53's.
And yes, removal is very easy, just remove a couple screws and expanding plastic rivets from underneath, and then pop the door sill off. Door sill will likely be bent, thus destroyed, and you should have only ONE clip break...all the others should be okay. when you pull the clips will likey remain in the car, Don't start pulling on them, simply rotate 45 degrees and they slide right out. there is one clip on each side that will not rotate out...it has to be broken.
Although I have never broken more than one clip, its always good to have extra clips laying around. along with expanding rivets.
And yes, removal is very easy, just remove a couple screws and expanding plastic rivets from underneath, and then pop the door sill off. Door sill will likely be bent, thus destroyed, and you should have only ONE clip break...all the others should be okay. when you pull the clips will likey remain in the car, Don't start pulling on them, simply rotate 45 degrees and they slide right out. there is one clip on each side that will not rotate out...it has to be broken.
Although I have never broken more than one clip, its always good to have extra clips laying around. along with expanding rivets.
Thread
Thread Starter
Forum
Replies
Last Post
ECSTuning
Vendor Classifieds
0
08-28-2015 12:26 PM
ECSTuning
Vendor Announcements
0
08-19-2015 12:51 PM
ECSTuning
Vendor Announcements
0
08-12-2015 01:24 PM