Interior/Exterior Should they stay or should they go?
Glenn-- You can check previous threads on the visor warning decals, but basically you just use nenatured alcohol, soak 'em for a minute by holding up some soaked layers of paper towel to the decals, then use the same paper towel to rub them right off. Motor on.
I like the idea of the stripes, however, I think the curve is a little TOO pronounced, especially in the head-on photos. I don't mean to be negative, as it seems everyone has been positive about them so far, that was just my first impression, that the angle of the curve needed to be less.
To MCJoe, i did try setting a bit straighter, but they went fall into the headlamp recess. and head on it looked worse. so I opted to put them where you see them.
To TMGRobyn, no it's Mequiers shine :smile:
Glenn
To TMGRobyn, no it's Mequiers shine :smile:
Glenn
>>To MCJoe, i did try setting a bit straighter, but they went fall into the headlamp recess. and head on it looked worse. so I opted to put them where you see them.
OK, now that I have that information, and now that I've come back to look at them a second day, I think I'm ready to give it a thumbs-up. Looking at it today, it didn't look as angled to me as I thought it was. Maybe it's the darkness of your car in the pictures, so it's hard to tell where the actual contours of the bonnet are. Also, the dealer-installed stripes are also angled, but I don't think it's as noticeable because there are two of them, if that makes any sense. I say keep the stripe, it is unique (but probably won't be for long, judging by some of the positive comments I've read). I like that you continued it on the boot also, I am thinking about getting boot stripes to match my regular bonnet stripes.
OK, now that I have that information, and now that I've come back to look at them a second day, I think I'm ready to give it a thumbs-up. Looking at it today, it didn't look as angled to me as I thought it was. Maybe it's the darkness of your car in the pictures, so it's hard to tell where the actual contours of the bonnet are. Also, the dealer-installed stripes are also angled, but I don't think it's as noticeable because there are two of them, if that makes any sense. I say keep the stripe, it is unique (but probably won't be for long, judging by some of the positive comments I've read). I like that you continued it on the boot also, I am thinking about getting boot stripes to match my regular bonnet stripes.
Thread
Thread Starter
Forum
Replies
Last Post



OOooooooooooo! Nice! Such classic stripes!
