Hi Everyone,

Has anyone installed the Schroth Quick Fit Pro in a 2006 GP? I am looking for install pix to determine what I need to do to install them.

Any help or direction to an existing thread / link would be appreciated.

Thanks!

 

Is that possible since there's no rear seats?

 

BAVAUTO, I have seen pix of the harnesses installed. Just not detailed installation process pix. Was hoping to find some of those. From what I understand I need to buy the rear / center seatbelt receivers and will need to locate the outboard seatbelt anchor position. It will require some fitting, but I will most likely buy back up pieces so that I can return to stock.

 

You could go to a junk yard and get the measurements for the rear seatbelt attachment points and the necessary hardware then I think you would be all set.

 

I just use the CG-Lock in the GP rather than adding the extra seat belt hardware. Works OK but of course not as good as a Harness.

 

More info here:

https://www.northamericanmotoring.co...ml#post1473899

https://www.northamericanmotoring.co...lts-on-gp.html

http://www.gpmini.net/wp/2007/04/harnessing_the_gp/