Hi guys.

I have been trying to reprogram a replacement ECU for a MINI R60 COUNTRYMAN (R056-14-07-500/DEV CODE: R60).

• I have the correct K+DCAN cable, with the switch in the correct position.
• INPA reported connections to the engine successful
• The Chassis & VIN FA/FG were read successfully by NCS by following the steps documented in the next bullet point
• I followed a PDF named: NCS_DIY.pdf - which was successful at all stages, without any major errors, (see attached to the post) with TWO caveats:
  • Step 67, there was no "BC_DIGITAL_V" in my FSW_PSW.MAN
  • In Step 77, the "SG_CODIEREN" did not return a positive result and failed to write the code
  • I selected the F2 job again and instead chose: "SG_CODIEREN_OHNE_FG"
  • On execution, the code then wrote successfully. (Confirmed in the main window with "Job Ended")
  • Moving on Step 81, I could not really understand what was being said and I did see what it was relating to.

I have done no further work today, as my battery was getting low and I could hear the vehicle battery becoming drained, especially following a dashboard warning! I have a power supply and will continue tomorrow.

My questions are:
1. Does it sound like I have managed to code the ECU?
2. Are there any files I can provide to prove it, (I have not amended any files from the appropriate directories)
3. What else can I and should I check when I next connect into the vehicle?

Any advice, previous experience from you experts and insights will be hugely appreciated - happy to also pay someone who knows what to look for!

All the best,
David

 

Find attached here -

 

Anyone??