Afternoon everyone,

I was considering swapping in the JCW muffler for a bit more volume from my exhaust and stumbled across the plain and simple muffler delete that seems to sound pretty dang good. Considering the chances that this may not be quite up my alley I'd like to have the shop cut the exhaust at the same length as the factory JCW mid pipe so if I don't like it I can simply swap the muffler in and clamp it on.

Does anyone have measurements either from the muffler to the cut or from the mid pipe to the muffler where I need to cut the pipe?
Or if anyone has a JCW Midpipe for not too much I'd be open to just picking one of those up as well.

 

Bumpin this guy up, anyone have any thoughts on where to make the cut or should I just go for it?

 

I “believe” there are dimples on the OEM pipes that mark the cut points. (my Clubman has them)