The code reader I have is generic and doesnt tell me what the make specific codes are. Can someone with a book of the engine codes tell me what P01689 is please?

 

the code should be 5 digit

P=powertrain
0=SAE
1=air/fule induction

ae you sure about that # ?

you have a 2004 right?

 

fairly sure. why? cant find it? Its easy to throw it, so ill go do it and come back

 

the book goes from p0141 o2 sensor then goes to p0171 system too lean bank one.

 

P1689: Electronic Throttle Control Monitor Level 2/3 Torque Calculation Error.

 

p1689 is "Electronic Throttle Control Monitor Level 2/3 Torque Calculation Error" Good luck.


Motor on

 

wow... sounds fun. how about

P0107
P0108

?? You think this would be a wiring harness, throttle body, or throttle position sensor problem??

 

Greatbear with the info again!!! Unbelievable!! How do you do that!?

 

P0107 manifold absolute pressure / barometric pressure circuit circuit low input
P0108 manifold absolute pressure / barometric pressure circuit circuit high input

Check your T-MAP sensor near the electronic throttle valve housing.

 

Ancient Ursine Secret!

 

It won't do you much good to just get the code number translated. The code will tell you which diagnostic tree to follow. You will then need a manual to folow the proper diagnostic procedure. This will tell you why that part is providing a signal to the computer that is outside of the expected parameters. This MAY be due to the part being defective, but it may also be caused by many, many, other things. Codes mean very little by themselves. You must follow the diagnostic procedure or you will just end up "throwing parts at a problem" and hoping to get lucky. That is fine if you are a dealership mechanic that gets paid for replacing parts and the factory is paying for the parts, but dosen't work very well for actually correcting a problem.

 

I know... I just needed to know whether I had a vacuum leak or a mechanical error. Now I just gotta track it down.

 

If you have altered your throttle body or added something like the AGS, you could throw this code. This is one in a series of non-generic ("P1" instead of "P0") codes relating to the drive-by-wire throttle system. Early versions of the AGS came with an extension cable to connect the relocated throttle body to the engine harness. Some of these cables have been defective or intermittent.

 

Got another one for anybody with that handy little book.

P1109

Thanks

 

P1109 Manifold Air Pressure too High in Deceleration

 

Jason,
Mini replaced the bypass valve, in the stock car that I have, after that code popped up. I don't know if that was actually the problem, but that's what they did.

Edit: p1689 was programmnin. p1688 was bypass valve.

 

P1109 just popped up for me over the weekend. Any Idea on a fix?

Doesn't look like a popular code around here.