2002 Mini Cooper R50 Can not Reset Immobilisation seed on INPA
#1
2002 Mini Cooper R50 Can not Reset Immobilisation seed on INPA
Hello,
New to the site, I Just purchased a 2002 Mini R50. It was not running when I bought it. After going through all the possible issues I checked the status of the DWS on INPA and the Immobilizer is engaged. I tried to reset the Immobilization seed but an error saying that it cannot communicate with the unit pops up. It will communicate with the ECU but nothing else. I made sure that pin 7 and 8 are bridged on the OBD II still no go. Could it still be the cable or could the software that I received with the cable not be complete? If the software is not complete, does anyone have a known good software? I have tried a few that are out on the net but they do not have a selection for R50. Any help would be greatly appreciated.
New to the site, I Just purchased a 2002 Mini R50. It was not running when I bought it. After going through all the possible issues I checked the status of the DWS on INPA and the Immobilizer is engaged. I tried to reset the Immobilization seed but an error saying that it cannot communicate with the unit pops up. It will communicate with the ECU but nothing else. I made sure that pin 7 and 8 are bridged on the OBD II still no go. Could it still be the cable or could the software that I received with the cable not be complete? If the software is not complete, does anyone have a known good software? I have tried a few that are out on the net but they do not have a selection for R50. Any help would be greatly appreciated.
#2
#3
Thread
Thread Starter
Forum
Replies
Last Post
bcman
Electrical
4
07-05-2014 08:27 PM
d454brisson
Electrical
0
04-27-2014 06:55 AM
everlast
Electrical
6
06-24-2013 07:13 AM