Stock Problems/Issues Discussions related to warranty related issues and repairs, or other problems with the OEM parts and software for MINI Cooper (R50), Cabrio (R52), and Cooper S (R53) MINIs.

Stalling/engine dying on MCSa

Old Apr 3, 2015 | 05:37 PM
  #1  
weezer2282's Avatar
weezer2282
Thread Starter
|
5th Gear
iTrader: (1)
Joined: Jun 2005
Posts: 782
Likes: 0
From: San Antonio
Stalling/engine dying on MCSa

A month ago my 2005 S auto had the engine stumble at a red light and the ecs and eml lights came on. The car recovered and the warning lights went off. It lasted for a couple miles then stumbled really bad while driving and the previous lights came on plus the engine temp, battery, and DSC and the engine cut out. I pulled to the side of the freeway and after a while started it back up to get it off the freeway and to a parking lot where it died again, and wouldn't start anymore and wouldn't start a few days later at the dealer. They replaced the crank pulley, oil pan gasket, power steering hoses, and timing case gasket. When I got it back it was consuming some coolant, but held consistent the last week and a half. Besides that it was running ok until yesterday. I went for a short drive and when I got back it was idling waiting for the garage door to open and the engine cut out. Engine and oil had gotten to operating temperature. Think the battery and temp light came on. It restarted right up to get it in the garage. Coolant looks ok in the tank. With the car off there is half a hole showing on the belt tensioner. The belt had been replaced about 6 months before this happened. I've got a 17% pulley. Any thoughts?
 
Reply
Old Apr 9, 2015 | 05:25 PM
  #2  
fozzy's Avatar
fozzy
2nd Gear
iTrader: (1)
Joined: Dec 2014
Posts: 131
Likes: 0
From: Puyallup, WA
Any updates on your issue? I have heard that they do weird things when the battery is going out. . May be worth checking. .
 
Reply
Old Apr 10, 2015 | 02:11 PM
  #3  
Aspen's Avatar
Aspen
4th Gear
Joined: Apr 2012
Posts: 424
Likes: 26
From: Kanuckistan
Your dealer replaced 4 things that have zero to do with a stalling car. It's not the tensioner either. There is big thread on this issue, unfortunately I don't think anyone has pinpointed the cause. My car did it a couple times where it started then died or started and ran rough. Been flawless for last 6 months. Could be an electrical issue, ECU fault, dirt in the fuel system???
 
Reply
Old Apr 11, 2015 | 03:28 PM
  #4  
weezer2282's Avatar
weezer2282
Thread Starter
|
5th Gear
iTrader: (1)
Joined: Jun 2005
Posts: 782
Likes: 0
From: San Antonio
It's been fine so far since that last time. Do notice the engine temps go down quite a bit with the heater on and it seems to run better than with the heater off. I think I'm going to bleed the cooling system. Could have air from when the crank pulley went bad.
 
Reply
Old Apr 11, 2015 | 03:32 PM
  #5  
weezer2282's Avatar
weezer2282
Thread Starter
|
5th Gear
iTrader: (1)
Joined: Jun 2005
Posts: 782
Likes: 0
From: San Antonio
Unless it is related to that long transmission thread. It is happier idling in neutral.
 
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
patsum
R50/R53 :: Hatch Talk (2002-2006)
26
May 29, 2021 06:29 PM
PsychoRallye
R50/R53 :: Hatch Talk (2002-2006)
21
Feb 17, 2019 06:08 AM
wildwestrider
R50/R53 :: Hatch Talk (2002-2006)
11
Jan 29, 2016 05:06 PM
rustof
R50/R53 :: Hatch Talk (2002-2006)
11
Sep 25, 2015 10:35 AM
ShadyCoop
R56 :: Hatch Talk (2007+)
10
Sep 8, 2015 04:50 PM


Thread Tools
Search this Thread

All times are GMT -7. The time now is 06:15 PM.