FS:: COMPLETE First Gen part out :(
#1
COMPLETE First Gen part out :(
Category: Exterior
Price: $0
Private or Vendor Listing: Private Listing
Part fits (you may select multiples): R50, R52, R53
Location (Region): NorthEast
Item Condition: Used
All parts will be coming from a garage-kept pepper white, peanut butter leather interior 2003 Mini Cooper Base (R50).
Anyway, I was involved in an accident and am trying to recoup my losses. As far as the engine, it still runs, less than 38,000 miles. Everything under the hood is stock with the exception of the DDM cold air intake, which pairs well with the, also unaffected, Megan exhaust! Apparently those are hard to find now...impact was only made on the front left and right panels. I also have the M7 top and middle grills (bottom did not fit the r50).
Rear: everything is available except suspension.
Interior: front, rear and side air bags deployed, otherwise everything else is still available.
Wheels: stock 7-hole (Imola) wheels w/ tires, 75-80% tread but one will need to be replaced. These wheels were taken off at around 20,000 miles and not involved in the accident.
Any questions, please feel free to ask as I realize there is a lot I haven't mentioned. This accident really broke my heart...but broke my mini even more:( Hoping that it won't all completely go to waste and someone can take advantage of my loss! Time is somewhat limited as I have two weeks to part out what I can then...bye bye forever, so get what you can while you can!
#5
No arm rest. Let me make sure I can remove those things without damaging them and I'll get back to you ASAP.
Trending Topics
#9
#15
That's a negative on the mirror but thanks so much for the word of encouragement! not quite sure what's next...
#16
Not sure about the mirror caps...I'll have to look into it. The logos have been claimed, I just have to figure out how to remove them without damaging them. If it falls through, I'll let ya know!
#18
A pillar trim
Is the driver side exterior A pillar trim available?
Just a note to remove the emblems use fishing line or nylon thread, work from the wing tip to the center.
be careful about the two post that fix the emblems to the car. work the thread around the top and bottom for the center section, then use a thin stick to pry the center section loose.
Hope this helps.
Just a note to remove the emblems use fishing line or nylon thread, work from the wing tip to the center.
be careful about the two post that fix the emblems to the car. work the thread around the top and bottom for the center section, then use a thin stick to pry the center section loose.
Hope this helps.
#19
Hey, jaymi. Lousy luck with your MINI; hope you weren't banged up.
I'm in need of a power steering pump, the rigid line between the pump and power steering fluid reservoir, and -- most painfully for me -- all wiring between the pump and wherever the wires terminate. Still not sure what happened to my pump, but it basically caught fire and melted the connectors and a bit of the wiring. I've got an '06 R53, but I think these parts are the same for both our cars.
Are those parts still available? Would you be willing to ship to 02155?
I'm in need of a power steering pump, the rigid line between the pump and power steering fluid reservoir, and -- most painfully for me -- all wiring between the pump and wherever the wires terminate. Still not sure what happened to my pump, but it basically caught fire and melted the connectors and a bit of the wiring. I've got an '06 R53, but I think these parts are the same for both our cars.
Are those parts still available? Would you be willing to ship to 02155?
#24
Is the driver side exterior A pillar trim available?
Just a note to remove the emblems use fishing line or nylon thread, work from the wing tip to the center.
be careful about the two post that fix the emblems to the car. work the thread around the top and bottom for the center section, then use a thin stick to pry the center section loose.
Hope this helps.
Just a note to remove the emblems use fishing line or nylon thread, work from the wing tip to the center.
be careful about the two post that fix the emblems to the car. work the thread around the top and bottom for the center section, then use a thin stick to pry the center section loose.
Hope this helps.