Hello all, I just ended up getting a new scanner for my car(Autel MD808p) to figure out my issue. Is there anyway anyone can help please, here is what I have replaced and here are the codes:




The codes:

2C01(High pressure fuel, plausibility Pressure too low)

2EFE(Combustion misfires, several cylinders: detected

2F00(Combustion misfire, cylinder 2: detected)

2EE2(Combustion misfiring, several cylinders: damaging exhaust gas after start sequence)

2EE9( Combustion misfiring, cylinder 2: damaging exhaust gas after start sequence)

Please help! This is my daily 😩

 

Weird. I would have said your hpfp, but see you replaced that.

I think you need to figure out that fuel pressure before anything else.

does your scanner show you fuel pressures?

 

Well the HPFP was replaced about a year ago. Wonder if it failed again already, and I’m not sure I will go through it and check tomorrow.