I finally got time to install my new silicone intake hose along with noise generator delete pipe and a high flow pre intercooler charge pipe in my 2014 R61S paceman. It was all fine and good until I drove it a little. Cel came on checked it and it was the P035A code. Did my research and came to realize that it was due to not having it connected with the new intake hose lines. The new hose did not come with any way to connect the sensors to it. I am not sure if anyone else had done this or if anyone has an options to fixing this issue? I’m think of slotting a hole and purchasing a new Pcv sensor? The issue is I cannot find the sensor for purchase but it’s self. If anyone has opinions or anything about this information I’d greatly appreciate it!

 

Same thing happened to me. Ended up going with an NM intake which comes with two resistor packs that plug into the PCV heater plugs and prevent the CEL.