Does anyone have the specs for how these stripes are applied?

 

I don't have any specs for applying stripes but YouTube must have something. I used a plastic scrapper and started in the middle to apply the stripes on my R53. Measure really well.

 

Wet and a-line then squeegee. Painter tape holds it in place.

 

I applied stripes last summer. I taped a string from emblem ot emblem to make sure they were centred correctly, and follow these instructions. I used the business end of a silicone kitchen spatula as a squeegee. Came out pretty good.

Here are the instructions I received and followed:


Here's before and after pics:

 

Was talking about the space between them.. looks like 1 inch

 

The one I bought came as two stripes on a single sheet. No measurement necessary.
But since you're asking, there is a 3cm gap, and each stripe is 13cm wide.

 

Thanks!

 

Question, where did you get the stripes? Just removed mine and looking to replace them