R56 Scan gauge II and boost
Thread Starter
|
3rd Gear
Joined: Jan 2012
Posts: 194
Likes: 2
From: Simi Valley, CA
Scan gauge II and boost
Just installed a SGII in my 08 MCS and have a question about boost.
In the MAP mode with the engine off it reads 14.0 which is correct for my location. At idle it's about 5.0..then as you drive it goes up depending on how far you get into the throttle.
In the BST mode at idle it's about 9 psi and goes up as well etc.
Is there a way to set a cal to "zero" this offset out so it reads the value without the math?
In the MAP mode with the engine off it reads 14.0 which is correct for my location. At idle it's about 5.0..then as you drive it goes up depending on how far you get into the throttle.
In the BST mode at idle it's about 9 psi and goes up as well etc.
Is there a way to set a cal to "zero" this offset out so it reads the value without the math?
Thread
Thread Starter
Forum
Replies
Last Post
R50/53 Help please.. Odd issue.
PsychoRallye
R50/R53 :: Hatch Talk (2002-2006)
21
Feb 17, 2019 06:08 AM
Interior/Exterior Getting Through the Firewall
papawhiskey
Interior/Exterior
1
Sep 30, 2015 02:50 PM
EVMini
R56 :: Hatch Talk (2007+)
4
Sep 28, 2015 10:20 AM