Navigation & Audio Wiring routing when installing factory CD changer
Thread Starter
|
3rd Gear
Joined: Aug 2008
Posts: 162
Likes: 0
From: Durham, NC
Wiring routing when installing factory CD changer
Hi:
I'm looking to get a factory cd-changer for my '05 MCS. My car has the plugs taped in the passenger side cubby hole, but how do I route the cables from the wiring, out of the cubby hole, and into the changer itself? I don't see any holes in the cover plate, nor in the panel itself, for getting two wires/plugs out of there. Do I need to leave the cubby hole cover plate semi-loose so I can get the wires through the gap between the edge of the panel and the cover plate? That will look cheap and unfinished
I'm looking to get a factory cd-changer for my '05 MCS. My car has the plugs taped in the passenger side cubby hole, but how do I route the cables from the wiring, out of the cubby hole, and into the changer itself? I don't see any holes in the cover plate, nor in the panel itself, for getting two wires/plugs out of there. Do I need to leave the cubby hole cover plate semi-loose so I can get the wires through the gap between the edge of the panel and the cover plate? That will look cheap and unfinished
OVERDRIVE
Joined: May 2005
Posts: 8,233
Likes: 127
From: San Francisco
Thread Starter
|
3rd Gear
Joined: Aug 2008
Posts: 162
Likes: 0
From: Durham, NC
Look at these installation instructions: http://www.motoringfile.com/howto/CD%20Changer.PDF
Thanks!!!
Thread
Thread Starter
Forum
Replies
Last Post
igzekyativ
MINIs & Minis for Sale
34
Jul 16, 2020 12:54 PM
igzekyativ
MINIs & Minis for Sale
28
Dec 23, 2015 10:36 AM
squawSkiBum
MINI Parts for Sale
15
Oct 2, 2015 09:21 AM
Navigation & Audio MINI Branded nuvi 360 Installation
Super Coop
Navigation & Audio
0
Aug 17, 2015 05:09 PM