Category: Drivetrain
Price: $160
Private or Vendor Listing: Private Listing
Part fits (you may select multiples): R55, R56, R57, R58
Location (Region): West
Item Condition: Used

K&N Typhoon Intake 69-2023ts intake. For N18 engines. Not positive on fitment, but I think this will fit all N18 engines. I don't guarantee fitment. But I do know it wont fit N14 engines with 4 air cleaner bolts.

I had this installed on my 2013 JCW R56 hatchback for a couple of months. Less than 1,000 miles. Nothing wrong with it. A very good aftermarket intake system. Just a little bit too loud for me. (What can I say? I'm old.) Going back to factory.

Looks basically new. If you want a little bit of extra intake noise, amplified exhaust sound, and some increased blow-off sound, this is for you. Also it looks great under the hood. Probably offers extra HP as advertised. But all I have is butt dyno figures.

This may or may not ship in the original K&N box, depending on shipping cost. May come in generic or flat rate boxes. But it will come with all parts, necessary installation hardware, and instructions.

$160 shipped to the lower 48. No international shipping please. PM an offer if you'd like, but please don't be insulting.

(I'll be out of town from 5/17-5/23, so if you reply during that time, please be patient. I'll get back to you when I'm back in town.)

 

What's the part number on the metal heat shield? It's stamped on the drivers side. It should be 073149 fits JCW models or 073130 fits S models.

 

Thanks

 

This is the K&N 69-2023TS kit listed to fit S models, 2011 and later. The heat shield is P/N 073130. The heat shield P/N 073149 that is included in the 69-2025TS kit that is listed to fit JCW models only fits the N14 motor lower airbox with 4 bolts, which was not installed on JCW models later than mid-2012.

I know this because I bought the 69-2025TS before this, and found out the hard way that K&N's fitment guide is wrong. I even sent them a message telling them this, including pictures, but they don't seem to believe me.

Anyway, long story short: this is the setup listed to fit S models, 69-2023TS, but it did fit on my N18 JCW where the setup listed to fit JCW models did not. If your engine is an N18, and the air cleaner box has 3 bolts, and not 4, this should fit.

Hope this helps.

 

Replied. I'll follow up tomorrow afternoon. Thanks.

 

It helps cause I just ordered #073130 because #073149 didn't fit my 2011 S N18. Had I known earlier I would of bought your kit.

 

Bummer. Best of luck.

 

If you still have the intake, I'll buy it from you. I have a '14 R60 S-model with N18 engine. Send me the details and I'll make payment tonight.

 

PM sent.

[ETA] Actually 2 sent. I just checked K&N's site to see if this fits your Countryman, and according to their site it does not. Now they were wrong about whether it would fit my JCW, so I can't say one way or the other, and I don't know what makes your N18 different from any other N18, but I don't really want to saddle you with a part that neither of us knows whether it fits your car. You can decide if you want to risk it, but I wanted you to make an informed decision.

 

Intake is sold. Moderators can close the thread.