MINI Parts for Sale Search and shop for all your MINI parts here!
Sponsored by:
Sponsored by:
Parts Search
Keyword:

Category:

Price:

Private or Vendor Listing:

Part fits (you may select multiples):















Location (Region):

Item Condition:


Cars Search
Keyword:

Year:
(Range)

Make:

Model:

Price:

Mileage:

Color:

Private or Dealer Listing:

Location (Region):

FS:: GP2 JCW Aero Kit

 
Thread Tools
 
Search this Thread
 
Old Jan 21, 2014 | 12:10 PM
  #1  
Alpha Motoring's Avatar
Alpha Motoring
Thread Starter
|
6th Gear
15 Year Member
iTrader: (10)
Joined: Jan 2007
Posts: 2,924
Likes: 62
From: Bel Air, California
GP2 JCW Aero Kit

Category: Exterior
Price: $1600
Private or Vendor Listing: Private Listing
Part fits (you may select multiples): R56, R57, R58, R59
Location (Region): SoCal
Item Condition: Used

Hi,


Up for sale is a complete GP2 John Cooper Works Aero Kit for your R56 MINI. This aero kit was removed off a 2013 GP2 with around 6,000 miles. There are some minor wear but there are no cracks or gouges. The side skirts were removed off another R56 with approximately 8,000 miles. Both were removed off a Southern California car that has never seen salted roads/snow.



Front: The front bumper includes everything you would need for the install. I’m including the 3-piece JCW lip, fog light bezel, fog light, lower grill and GP2 red brake ducts. I would advise replacing the brake ducts due to minor blemishes for the perfectionists. These brake ducts are relatively cheap at around $35 for the pair. I will also be including the original JCW badge for the front bumper. As an added bonus I will also be including the fog lights and bulbs removed from the GP2. I will also be including the outside temperature sensor with the bumper. This is everything you’ll need minus your original clips to install the front bumper.


Side: These side skirts were removed off a R56 with 8,000 miles. Currently they’re painted Chilli Red but will need to be repainted due to scratches. Two pieces were damaged when taking them off, the part number for those are 51710445884 and 51710445883 both of which are relatively cheap $70-$75. One side skirts has two very minor cracks (2mm long) which can easily be repaired by any body shop.



Rear: The rear bumper also includes everything you’ll need for install. As you can tell I’m including both the left and right width extensions, GP2 Diffuser (Center Section) two bezel for the reverse lamp and rear fog light and also the rear fog light housing and also the reverse light housing.



Arches: The set of wheel arches were also removed off the GP2, these are great replacements for your faded wheel arches.


Front Grill: The front grill was removed off a 2013 GP2 I’m including the grill and the lower frame/grill trim in factory blackline.



This kit new would sell for around $3,391.35 and the lowest price I found online with a wholesale account is $2,388.69 without the GP2 diffuser. I am not looking to ship this aero kit and it is for pickup only in Southern California (Los Angeles area). Factoring the little pieces that need replacement I am asking a very fair $1,600.00 OBO for the entire lot.

Prospective buyers can inspect the items at anytime. Have a good day!































 
Attached Thumbnails GP2 JCW Aero Kit-dsc00601.jpg   GP2 JCW Aero Kit-dsc00602.jpg   GP2 JCW Aero Kit-dsc00604.jpg  
Old Jan 21, 2014 | 01:45 PM
  #2  
igzekyativ's Avatar
igzekyativ
5th Gear
Joined: Jan 2014
Posts: 893
Likes: 1
From: Ashburn, VA
I know you probably don't want to part this out but I am interested in the Red GP2 Red Brake Ducts (Part #: 51747330891K) if you do want to part this out
 
Old Jan 22, 2014 | 10:13 AM
  #3  
p8ntbollr's Avatar
p8ntbollr
2nd Gear
iTrader: (1)
Joined: Nov 2010
Posts: 139
Likes: 0
If you're willing to part the diffuser I'd be more than willing to pick that up as well
 
Old Jan 22, 2014 | 01:29 PM
  #4  
p8ntbollr's Avatar
p8ntbollr
2nd Gear
iTrader: (1)
Joined: Nov 2010
Posts: 139
Likes: 0
Of course I could trade you my stock JCW diffuser + cash so you could still well the whole bumper
 
Old Jan 22, 2014 | 04:21 PM
  #5  
ra2fanatic's Avatar
ra2fanatic
6th Gear
iTrader: (6)
Joined: Feb 2010
Posts: 2,936
Likes: 22
From: SoCal
I don't know how different the N18 is compared to the N14, but the JCW sides also require 2 pieces that allow it to bolt underneath. Without them they'd only be secure from the door sill area only.



Also you're not supplying the other half of the brake ducts which are located on the front carrier beam. This would complete the brake ducts to exit into the wheel housing.

Be careful what you would call a complete GP2 kit. It's close, but not entirely. Rear diffuser is also missing the 2 brackets and the tunnel connectors.

Lastly, you're not including the upper and lower gloss black grill surrounds.
 
Old Jan 22, 2014 | 07:19 PM
  #6  
Alpha Motoring's Avatar
Alpha Motoring
Thread Starter
|
6th Gear
15 Year Member
iTrader: (10)
Joined: Jan 2007
Posts: 2,924
Likes: 62
From: Bel Air, California
Originally Posted by ra2fanatic
I don't know how different the N18 is compared to the N14, but the JCW sides also require 2 pieces that allow it to bolt underneath. Without them they'd only be secure from the door sill area only.



Also you're not supplying the other half of the brake ducts which are located on the front carrier beam. This would complete the brake ducts to exit into the wheel housing.

Be careful what you would call a complete GP2 kit. It's close, but not entirely. Rear diffuser is also missing the 2 brackets and the tunnel connectors.

Lastly, you're not including the upper and lower gloss black grill surrounds.
You are correct, I am not here to mislead any potential buyers. Therefore I went into the dealership and picked up two brand new brackets. I also picked up a new unpainted S rear diffuser for the JCW bumper as I know some people may not want the GP diffuser.

If you look at the photos the grill DOES include the lower trim, but I understand some buyers may want the upper grill as well, I will include that as well.

LCI cars have a different design on the brake ducts unlike pre 2011 cars. I cannot confirm or deny whether there is additional parts needed to make it work.

Even though I just spent a couple hundred correcting this mistake, I will still honor the same price.

I also bought JCW door sill inserts, if everything is bought at my asking price I will be including these!

Thanks John!!
 
Old Jan 22, 2014 | 07:26 PM
  #7  
ra2fanatic's Avatar
ra2fanatic
6th Gear
iTrader: (6)
Joined: Feb 2010
Posts: 2,936
Likes: 22
From: SoCal
Cool cool. I definitely mean no disrespect or wanted you to get into any backlash if someone bought it and said "hey i'm missing this, etc etc". No worries Joseph!
 
Old Jan 23, 2014 | 07:41 AM
  #8  
Charmuth's Avatar
Charmuth
1st Gear
Joined: Jul 2013
Posts: 50
Likes: 0
From: DM(V)
Would you sell the rear bumper alone? Thanks!
 
Old Jan 23, 2014 | 04:32 PM
  #9  
MiniErik's Avatar
MiniErik
4th Gear
iTrader: (2)
Joined: Apr 2013
Posts: 312
Likes: 0
From: Maryland
Originally Posted by Charmuth
Would you sell the rear bumper alone? Thanks!
i would be curious if youd part and ship the front
 
Old Feb 4, 2014 | 04:20 PM
  #10  
ryanschram's Avatar
ryanschram
4th Gear
iTrader: (2)
Joined: Apr 2010
Posts: 307
Likes: 4
From: Waukesha, WI
Originally Posted by Charmuth
Would you sell the rear bumper alone? Thanks!
I would take the front!
 
Old Feb 4, 2014 | 09:57 PM
  #11  
RMatsubara's Avatar
RMatsubara
1st Gear
Joined: Oct 2013
Posts: 20
Likes: 0
From: Clovis CA
Why couldn't the collar be in pepper white grrrrrrrr!
 
Old Feb 4, 2014 | 09:58 PM
  #12  
ryanschram's Avatar
ryanschram
4th Gear
iTrader: (2)
Joined: Apr 2010
Posts: 307
Likes: 4
From: Waukesha, WI
Originally Posted by RMatsubara
Why couldn't the collar be in pepper white grrrrrrrr!
because GP2 only comes in 1 color?
 
Old Feb 4, 2014 | 10:00 PM
  #13  
RMatsubara's Avatar
RMatsubara
1st Gear
Joined: Oct 2013
Posts: 20
Likes: 0
From: Clovis CA
Originally Posted by ryanschram
because GP2 only comes in 1 color?
How much you think a paint shop charge to paint those4 pieces matching my pepper white?
 
Old Feb 4, 2014 | 10:01 PM
  #14  
ryanschram's Avatar
ryanschram
4th Gear
iTrader: (2)
Joined: Apr 2010
Posts: 307
Likes: 4
From: Waukesha, WI
most likely, at least $500
 
Old Feb 4, 2014 | 10:04 PM
  #15  
RMatsubara's Avatar
RMatsubara
1st Gear
Joined: Oct 2013
Posts: 20
Likes: 0
From: Clovis CA
Wished money grew on trees :-(
 
Old Feb 4, 2014 | 10:06 PM
  #16  
ryanschram's Avatar
ryanschram
4th Gear
iTrader: (2)
Joined: Apr 2010
Posts: 307
Likes: 4
From: Waukesha, WI
I would take the back, but being that i have a clubby, i just see that as being a nightmare
 
Old Feb 4, 2014 | 10:11 PM
  #17  
Alpha Motoring's Avatar
Alpha Motoring
Thread Starter
|
6th Gear
15 Year Member
iTrader: (10)
Joined: Jan 2007
Posts: 2,924
Likes: 62
From: Bel Air, California
Oops forgot to post I sold this a long time ago.
 
Old Feb 5, 2014 | 12:35 AM
  #18  
Anldyxp_R56's Avatar
Anldyxp_R56
3rd Gear
Joined: Nov 2013
Posts: 151
Likes: 1
From: W. Los Angeles, CA
Man, wish I had the money for this. I'm local in Westwood too. Need to save money for tuition though. Bump for a sweet kit!
 
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
igzekyativ
MINIs & Minis for Sale
34
Jul 16, 2020 12:54 PM
igzekyativ
MINIs & Minis for Sale
28
Dec 23, 2015 10:36 AM
ECSTuning
Interior/Exterior Products
2
Aug 7, 2015 09:51 AM
ECSTuning
Vendor Announcements
0
Aug 7, 2015 08:02 AM




All times are GMT -7. The time now is 04:28 AM.