Drivetrain (Cooper S) MINI Cooper S (R56) intakes, exhausts, pulleys, headers, throttle bodies, and any other modifications to the Cooper S drivetrain.

Drivetrain Akrapovic DP? Two words...

Thread Tools
 
Search this Thread
 
Old Jul 28, 2012 | 04:34 AM
  #1  
mcmmotorsports's Avatar
mcmmotorsports
Thread Starter
|
3rd Gear
iTrader: (4)
Joined: Jan 2012
Posts: 204
Likes: 0
From: Danbury, CT
Akrapovic DP? Two words...

BEAUT IFUL!

Can't wait to install it next week. On another note, I will have a slightly used, Riss Racing Catless DP for sale next week too.
 
Attached Thumbnails Akrapovic DP? Two words...-akra.jpg  
Reply
Old Jul 28, 2012 | 04:09 PM
  #2  
Liquid's Avatar
Liquid
4th Gear
15 Year Member
iTrader: (1)
Joined: May 2006
Posts: 522
Likes: 12
From: Makawao, HI
Let us know your thoughts once it's installed...looking on getting this for my wife at Christmas....and eventually for my new JCW :-)
 
Reply
Old Jul 28, 2012 | 08:06 PM
  #3  
chengchiro's Avatar
chengchiro
1st Gear
iTrader: (1)
Joined: Apr 2007
Posts: 26
Likes: 0
From: Norcal
Akra DP

You will love it, growls when on cam, lotsa pops and burbles. I have it on
my 09 jcw, better throttle response when starting out. Feels more torque
than before when running with the same alta/cobb map, helix fmic, and stock
exhaust, no drone. Another side benefit, slight increase of mpg. A very nice mod indeed. Enjoy and cheers!
 
Reply
Old Jul 28, 2012 | 09:01 PM
  #4  
calforhelp's Avatar
calforhelp
5th Gear
iTrader: (1)
Joined: Jan 2012
Posts: 754
Likes: 5
From: Glendale, CA
Exactly what chengchiro said. I noticed an instant improvement in the low end and a little more torque.

The few downsides I noticed:
-CEL came on after about 70 miles. It's supposed to go off by using these but you have to drill out the center a little larger to let the oxygen sensor fit inside. I haven't been able to get the hole to the correct size yet so I can't say for sure if this works to turn the light off.

-When first starting the engine from cold (after sitting for 8+ hours) the engine idles at around 1,100RPM and is way loud. After about 45 seconds it goes back to the normal 500-700RPM and is quiet but sounds great when stepping on the gas.

-When first installed the pops and burbles were unnecessarily loud. It was to the point that some of the pops sounded like fireworks were going off under my car. Way too loud and way too often. After about 1,000 miles on the DP the P&B are just as frequent but not nearly as loud and annoying. They sound great, almost like an Audi RS4.

-During the first 20 miles or so, the DP smoked and I thought I had an exhaust leak. It turned out it was just excess oil or contaminants burning off of the pipe but it was concerning at first.


So upon first installing, the power was instantly noticeable and great but there were some serious downsides for me. All of the downsides have disappeared after about 500 miles and now I love it and would have my MINI no other way!
 
Reply
Old Jul 29, 2012 | 01:56 PM
  #5  
chengchiro's Avatar
chengchiro
1st Gear
iTrader: (1)
Joined: Apr 2007
Posts: 26
Likes: 0
From: Norcal
To add to the more fun to drive quotient, adding the nm torque insert and nm short shifter really make the car drive more responsively. Inexpensive and easy to do and great value mods!!!
 
Reply
Old Jul 29, 2012 | 02:30 PM
  #6  
ThePenl's Avatar
ThePenl
3rd Gear
Joined: Nov 2010
Posts: 222
Likes: 2
Maybe the best quality performance DP in the market with 100cpi.

Have been runing the Akrapovic DP for the third year now without any problems whatsoever and loving it.

You made a great choice! Enjoy...
 
Reply
Old Jul 29, 2012 | 09:03 PM
  #7  
WayMotorWorks's Avatar
WayMotorWorks
Vendor
15 Year Member
Liked
Loved
Community Favorite
iTrader: (10)
Joined: Jul 2006
Posts: 10,621
Likes: 802
From: Atlanta, GA
This is what I keep saying about the Akrapovic Downpipe, the quality and fit is bar none.
 
__________________

HOTCHKIS | DDM | CRAVEN | AKRAPOVIC | NM ENGINEERING | MEGAN | FORGE | OS GIKEN | POWERFLEX and more


Reply
Old Jul 30, 2012 | 09:06 AM
  #8  
mbwicz's Avatar
mbwicz
6th Gear
iTrader: (4)
Joined: Aug 2011
Posts: 1,810
Likes: 53
From: Buffalo area, NY
Looks really nice. But did you really put it on the trunklid for the picture? Mother-in-law's car maybe?

Let us know how you like it....

Mike
 
Reply
Old Jul 30, 2012 | 09:10 AM
  #9  
mcmmotorsports's Avatar
mcmmotorsports
Thread Starter
|
3rd Gear
iTrader: (4)
Joined: Jan 2012
Posts: 204
Likes: 0
From: Danbury, CT
lol, that is the trunk lid of my track rat:



Install is complete. I like it. Slightly louder than the stock JCW exhaust (which is what I was after all along) and power loss from catless is negligible.
 
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Jerome R Jr W
R56 :: Hatch Talk (2007+)
13
Sep 29, 2015 11:42 AM
potterstein
R56 :: Hatch Talk (2007+)
5
Sep 11, 2015 11:45 PM
WayMotorWorks
Vendor Announcements
0
Dec 3, 2013 06:27 PM




All times are GMT -7. The time now is 07:31 AM.