Just received a Scangauge II and FlexPod Mount from Way Motorworks and it came with no instructions for the mount. Can anyone help with this?

Thanks,

DOC

 

I think so. In their misguided attempt at saving a few pennies, they don't supply instructions for any of their products. However, they do have this info online at their website.

If enough customers complain about this, maybe they'll change their ways?

 

Here's the page: http://www.waymotorworks.com/product...4&cat=0&page=1

Maybe I'm an idiot because I can't find the instructions. Tried a site search, too. Got it installed, but you always wonder whether you might have done a better job with some guidance from someone with some familiarity with the product.

DOC

 

That's because it's a Craven Speed product and the instructions are here:
http://www.cravenspeed.com/product_i...-1000-R140.pdf

 

Thanks, Richard.......

That got me close enough. The Craven instructions for the SCII mount are actually:http://www.cravenspeed.com/product_i...-1000-R190.pdf

I managed to get to the screws in the back of the tach w/o removing it by using an angle screwdriver. However, I could not see how to secure the SCII in the cradle w/o using Velcro. The instructions seem to suggest the cradle just "holds" it. Velcro works fine, but is there some other way?

DOC

 

Mine is a bit fiddley to get seated, but once you get it in, it stays. No velcro for me.

 

I used some double stick tape to "secure" it.