Electrical For discussions regarding wiring up electrical modifications such as radar detectors, brake light mods, power sockets, and driving lights in Cooper (R50), Cabrio (R52), and Cooper S (R53) MINIs.

Electrical Interior Light Problem

Old Apr 25, 2007 | 07:32 PM
  #1  
xnotfunkylex's Avatar
xnotfunkylex
Thread Starter
|
6th Gear
15 Year Member
iTrader: (3)
Joined: Jun 2006
Posts: 1,485
Likes: 2
From: Orange County. CA
Interior Light Problem

Yesterday I noticed that the dome light and underdash lights in my car stopped working. But the reading lights still work properly. I had my car in the shop today so they looked at it and didn't know what the problem was. And it isn't the fuse. Does anyone know a way to fix this? It is a little annoying not having any light in my car at night.

Kyle
 
Reply
Old Apr 25, 2007 | 08:45 PM
  #2  
whovous's Avatar
whovous
5th Gear
Joined: Sep 2004
Posts: 698
Likes: 0
Have you tried swapping in bulbs that you know work?
 
Reply
Old Apr 25, 2007 | 09:06 PM
  #3  
Greatbear's Avatar
Greatbear
Moderator :: Performance Mods
Joined: Mar 2003
Posts: 5,427
Likes: 6
From: A Den in Maryland
Do the lights come on using the pushbutton?

Try pressing and holding the button for 5 seconds or more. Doing this toggles the lights coming on with the door opened. The lights just might be disabled.
 
Reply
Old Apr 25, 2007 | 09:19 PM
  #4  
xnotfunkylex's Avatar
xnotfunkylex
Thread Starter
|
6th Gear
15 Year Member
iTrader: (3)
Joined: Jun 2006
Posts: 1,485
Likes: 2
From: Orange County. CA
I have LED's pluged in. And I will try holding the button down. Thanks for the advice.
 
Reply
Old Apr 25, 2007 | 10:07 PM
  #5  
rkw's Avatar
rkw
OVERDRIVE
Joined: May 2005
Posts: 8,233
Likes: 127
From: San Francisco
Assuming that your lights weren't disabled...

People have reported LED failures with surprising regularity. Did they all go out at the same time, or could they have been going out and you only noticed when the final bulb went out? If your boot light is working, see what happens if you swap the bulbs between the dome and the boot.
 
Reply
Old Apr 26, 2007 | 09:23 AM
  #6  
xnotfunkylex's Avatar
xnotfunkylex
Thread Starter
|
6th Gear
15 Year Member
iTrader: (3)
Joined: Jun 2006
Posts: 1,485
Likes: 2
From: Orange County. CA
I actually have the regular bulbs in as well. I just forgot to put that earlier. So I am running to lights essentially. Could this be the problem? Too many lights? And the boot doesn't work either with only the oem bulb.
 
Reply
Old Apr 26, 2007 | 10:14 AM
  #7  
rkw's Avatar
rkw
OVERDRIVE
Joined: May 2005
Posts: 8,233
Likes: 127
From: San Francisco
LEDs add so little electrical load that they should not be a problem to run in parallel with the regular bulbs. However, to diagnose this problem it would be better to disconnect them and run a completely stock configuration to remove any variables. Here is how the MINI is wired:

These lights are connected on the same circuit:
reading lights (front & rear)
vanity mirror lights
glovebox light

These are on a different circuit:
footwell lights
dome light

The boot light is on its own separate circuit.

By different "circuits" I mean separate power outputs from the BC1 computer. The fuse for all interior lighting is F14. Your symptoms are unusual and I'm not sure what to recommend. It's possible that your BC1 computer is at fault (hope you are still under warranty).
 
Reply
Old Apr 26, 2007 | 09:09 PM
  #8  
xnotfunkylex's Avatar
xnotfunkylex
Thread Starter
|
6th Gear
15 Year Member
iTrader: (3)
Joined: Jun 2006
Posts: 1,485
Likes: 2
From: Orange County. CA
Unfortunately I am not under warranty anymore. I think BMW plans it this way. I think some other things are going bad on my car as well. And only 54,000 miles on my 2002. I need to find a wrecked MINI to buy parts from I think.
 
Reply
Old Apr 26, 2007 | 09:10 PM
  #9  
xnotfunkylex's Avatar
xnotfunkylex
Thread Starter
|
6th Gear
15 Year Member
iTrader: (3)
Joined: Jun 2006
Posts: 1,485
Likes: 2
From: Orange County. CA
On a happy note, I would like to welcome third gear to my profile.
 
Reply
Old Apr 27, 2007 | 12:59 PM
  #10  
blorax's Avatar
blorax
1st Gear
Joined: Feb 2007
Posts: 39
Likes: 0
From: Los Angeles
Also, have you tried reversing the polarity of the led bulbs (assuming they are wedge bulbs)?

Originally Posted by xnotfunkylex
I have LED's pluged in. And I will try holding the button down. Thanks for the advice.
 
Reply
Old Apr 27, 2007 | 06:07 PM
  #11  
xnotfunkylex's Avatar
xnotfunkylex
Thread Starter
|
6th Gear
15 Year Member
iTrader: (3)
Joined: Jun 2006
Posts: 1,485
Likes: 2
From: Orange County. CA
The LED's are wired in and I used the info I found from the "light that boot" thread on here. Unfortunately it sounds like it is going to be expensive to fix. The dark has never sounded so good.
 
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
igzekyativ
MINIs & Minis for Sale
34
Jul 16, 2020 12:54 PM
phrza81
MINIs & Minis for Sale
9
Oct 10, 2015 11:37 PM
Mini Cooper r56 Pr
Drivetrain (Cooper S)
3
Aug 12, 2015 07:42 PM
ECSTuning
Vendor Announcements
0
Aug 7, 2015 08:02 AM
nismo4life
Stock Problems/Issues
3
Aug 5, 2015 08:31 AM


Thread Tools
Search this Thread

All times are GMT -7. The time now is 02:47 AM.