When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Can this change be done without lifting the engine again? Is there enough room to remove the existing 15% since a puller is no longer needed then slide in the 17%? Is it doable?
Might be possible, not exactly sure, would be tight though. I ended up just replacing the crank pulley with a 2% larger. Close to the same, and it is/ was a weak part on the early 53's.
Since I already have a 17%wmw that's why I was thinking if anybody has done it before. Also health wise I cannot do all those jacking up stuff anymore and also avoiding extra labor cost to install the smaller pulley.
