Drivetrain Exhaust Depot's IC piping! with pics
#30
#31
Hey everyone. I was interested when I saw the pics awhile back and thought to myself I can make that. So I went to Autozone today and bought single exhaust pipes, cut them to spec, cut my Alta tubes to spec, and connected everything myself. Including the turbo inlet tube. I just need to paint the pipes with something...it was pretty inexpensive in all, although, I own the proper tools. Anyways, pics when I install them.
#32
Hey everyone. I was interested when I saw the pics awhile back and thought to myself I can make that. So I went to Autozone today and bought single exhaust pipes, cut them to spec, cut my Alta tubes to spec, and connected everything myself. Including the turbo inlet tube. I just need to paint the pipes with something...it was pretty inexpensive in all, although, I own the proper tools. Anyways, pics when I install them.
I dont think to many people want to cut up a nice set of boost tubes to install a bov. Also i hope you put beads on the pipe because you will have a chance of having it blow off the silicon.
#33
well i only made the ic pipe off the turbo and the inlet...the other i didnt have a spare bov lying around lol it's basically what m7 sells but homemade on the ic part...however, I did have spare alta tubes so cutting them up wasn't an issue, otherwise I would of never haha. If it doesn't work properly then I'll switch back, didn't take much time anyways.
#37
#39
5th Gear
iTrader: (1)
Join Date: Apr 2008
Location: Santa Barbara, Ca
Posts: 719
Likes: 0
Received 0 Likes
on
0 Posts
Hi Hector. i am still saving up for this. I will have to do it in 2 parts how much for the whole setup without the forge BOV. still with the flange but that way I can get the BOV later??
I have an M7 strut brace, can you move the BOV down a bit? It looks like it will hit the Brace
I have an M7 strut brace, can you move the BOV down a bit? It looks like it will hit the Brace
Last edited by chakraj; 09-16-2008 at 09:12 PM.
#40
Hi Hector. i am still saving up for this. I will have to do it in 2 parts how much for the whole setup without the forge BOV. still with the flange but that way I can get the BOV later??
I have an M7 strut brace, can you move the BOV down a bit? It looks like it will hit the Brace
I have an M7 strut brace, can you move the BOV down a bit? It looks like it will hit the Brace
Thread
Thread Starter
Forum
Replies
Last Post
igzekyativ
MINIs & Minis for Sale
34
07-16-2020 12:54 PM
Drivetrain Magnaflow Exhaust Manifold for R53
blacklistedmini
Drivetrain (Cooper S)
33
10-27-2017 10:31 AM
JPMontes3
R50/R53 :: Hatch Talk (2002-2006)
5
08-24-2015 07:15 AM