Installed Koni springs yesterday and for some reason the back went down as expected but the fronts didn't move. Did I do something wrong? I reused everything except for new strut mounts. Should I have cut the bump stops? Please help me!!

 

Sorry, he said koni. Edited.

 

A few TSW lowering spring buyers had this issue from a bad batch.

 

I have Konis. Maybe I should contact them directly.

 

same here with the h&r stage 2 lowering springs..im amssuming since they are advertised to be 20% stiffer than stock..and they are...they are just to stiff up front to compress under the cars own weight.
looking into an adjustable coilover set.
sorry i was no help but your not alone!!!
good luck

 

Some say they do settle over time. It is possible not to have them inserted all the way in the arm too, also if you added camber plates, that is an increase you can't avoid.

 

I would wait a while to see if it settles. Cutting the bump stops wont change the ride height.

 

Springs can take up to a thousand miles to settle. Its only been a day, give it some time.....