m7 Strut Brace Install Question
Thread Starter
|
2nd Gear
Joined: Dec 2005
Posts: 150
Likes: 0
From: Santa Fe, NM
m7 Strut Brace Install Question
Is it as straight foward as bolt the plates down, then tighten the bolts on the slotted holes?
Or is there another method to the madness?
Blue loctite the bolts on the slots?
thx
Or is there another method to the madness?
Blue loctite the bolts on the slots?
thx
My little dose of LITHIUM
iTrader: (1)
Joined: Jul 2005
Posts: 2,435
Likes: 2
From: Albuquerque New Mexico
Should be in suspension forum, but here are my answers:
1. Installation is very straight forward. Loosen all 8 bolts (4 cap screws, 4 countersunk bolts), remove 6 nuts on strut towers, place plates over left and right towers and reinstall nuts or use new ones, adjust strut so it is nice and straight, tighten 8 bolts. There are no slots from what I could tell, but it has enough play at the plates to fit with no worries.
2. The method above works, but there could be others...
3. Loctite? Not necessary and probably overkill since you'll have to remove some bolts to get to the oil filter or header when you change them.
cheers,
1. Installation is very straight forward. Loosen all 8 bolts (4 cap screws, 4 countersunk bolts), remove 6 nuts on strut towers, place plates over left and right towers and reinstall nuts or use new ones, adjust strut so it is nice and straight, tighten 8 bolts. There are no slots from what I could tell, but it has enough play at the plates to fit with no worries.
2. The method above works, but there could be others...
3. Loctite? Not necessary and probably overkill since you'll have to remove some bolts to get to the oil filter or header when you change them.
cheers,
Thread
Thread Starter
Forum
Replies
Last Post
Mikli
R55 :: Clubman Talk (2008+)
13
Jun 26, 2019 05:58 AM
igzekyativ
MINIs & Minis for Sale
28
Dec 23, 2015 10:36 AM
squawSkiBum
MINI Parts for Sale
15
Oct 2, 2015 09:21 AM
JaysinStrife
Suspension
7
Sep 7, 2015 12:52 PM
