Hello, A little background: I bought this Mini with an over heated engine. It had a warped head, replaced that and put new ring, bearing, water pump, timing chain, etc in it. Have it running well except for the eccentric shaft. I have tried to get the computer to relearn the position of the shaft but it keeps rotating all the way counter-clock wise until the half engine light comes on and it goes into limp mode. It doesn't seem to reset when the key is put in either. I have replaced the eccentric motor with another used motor and have the same issue but this seems to be more software than hardware. Can anyone help? Thanks

 

Did you follow this?

https://www.newtis.info/tisv2/a/en/r...-gear/Db6g9sBW

 

Yes, i did it exactly the way they instructed. Except I don't know what they mean by "Check function of Digital Engine Electronics". Thanks Mike