My toggle switch panel has come loose from behind and the whole back bracket is floppy behind the fascia for all of the switches. The switches aren't able to be pushed to the point where they engage the windows to go down unless you reach under the panel and hold the bracket steady.

Has anyone else encountered this problem ? Any fixes that have been found instead of taking coop for a Dr's visit ? I was thinking super glue, but then again, the car is only 8400 miles old and shouldn't do this in the 1st place.

Feedback ?

Kesh420

 

I would avoid superglue like the plague.... unless you want to 'melt' the plastic... I'd say, w/o actually being able to see the setup, a low temp hot glue gun...

Rocketboy_X