passenger side motor mount
passenger side motor mount
Recently took in my 05 MCS for the scheduled maintenance. The service advisor said that the passenger side motor mount was leaking fluid and that this was common problem. The advsior said that the dealer replaced about 35 mounts in the last month. Any one else experience this issue? Is this a technical service bulletin? The dealership replaced it for free since it was under warranty, but this was the first car that I owned that had a motor mount go bad before 100k miles.
4th Gear


Joined: Jun 2006
Posts: 303
Likes: 5
Actually, my 03 MCS suffered the same problem (i.e., passenger side engine mount failure). There was a discussion as to whether the old mounts, which looked different, were oil-filled or not. First hand experience, I can tell you that they ARE! Even the service advisers told me that they were not and the oil must have been coming from somewhere else... Not true.
05-06 mounts tend to fail quite easily, whereas the older ones seem to require some force (e.g., mine surfaced after a clutch replacement; can you say "dealer-initiated-problem"?).
05-06 mounts tend to fail quite easily, whereas the older ones seem to require some force (e.g., mine surfaced after a clutch replacement; can you say "dealer-initiated-problem"?).
Same boat here... walked out to the garage yesterday and noticed an oil puddle under the passenger side area of the engine. I immediately popped the hood and saw oil under the motor mount. I can't remember if it was a thread here or at a local garage day where I saw one leaking as an example.
Going to make an appointment tomorrow to bring it in to be replaced. Shouldn't be a big deal from what I hear. I have an early '05 MCC (w/29kmiles).
Going to make an appointment tomorrow to bring it in to be replaced. Shouldn't be a big deal from what I hear. I have an early '05 MCC (w/29kmiles).
Last edited by MiniMac2005; Oct 21, 2007 at 06:30 AM. Reason: added mileage....
My 2005 S Cabrio JCW had the same problem. Found the puddle toward the right side of where the car is usually parked three days ago.
Mini of Murray says they also found a coolant leak at the same time, but everything fixed.
Mini of Murray says they also found a coolant leak at the same time, but everything fixed.
Mine is also leaking oil, before I bring it for service & possibly replace under warrenty Should I take off my TSW engine dampers?
I Bring my mini to LONG BEACH MINI, CA. any suggestion from fellow local owner who had same problem & had engine damper installed?
Thanks
05 MCS (45K miles)
I Bring my mini to LONG BEACH MINI, CA. any suggestion from fellow local owner who had same problem & had engine damper installed?
Thanks
05 MCS (45K miles)
Last edited by HABUTGO; Oct 19, 2007 at 10:15 AM.
Trending Topics
2004 build date 04's have the same mount as 05-06.
Mine was replaced once under warranty.
Now that I'm out of warranty and past two years since it was replaced, I'm in the middle of replacing it as I type.
That E12 torx bolt is a PITA!
I stripped the damn thing and had to cut it off (finally).Btw when I removed the upper bracket, I was able to jiggle the center post of the motor mount freely with almost no force.
The replacement one did not budge by hand. Edit: after installing it it does budge a little bit when rocking the engine.
Part # 22116778610 which I got for $70 shipped from Morristown MINI.
I have to pick up a new bolt tomorrow.
Last edited by LordOfTheFlies; Oct 21, 2007 at 06:10 AM.
04 MCS, 37,000 miles and I just had mine replaced last week. I've still got black gunk all over the underside of my hood. I also had both window motors replaced. I really wish stuff would stop breaking on this car. I've only got about 6 months left on warranty and I'm starting to get nervous.
To the guy who replaced the mount himself: how much did the replacement part cost?
To the guy who replaced the mount himself: how much did the replacement part cost?
From above:
I wouldn't worry about it. You'll have oil leak out of the damper until its empty. I was told that there is a rubber piece inside the metal housing that sits with the oil. You should be fine for a quick trip to the dealer.
Uh oh...I'm noticing that "golf ball in the glove box" sound and a stain similar to snappers'. I've been seeing little quarter-sized puddles as well...
How long can I run on it this way without causing further problems? I'm traveling all week and then plan to participate in a group event (highways and twisties, no auto-x or track). Probably 600 planned miles before a window to get it fixed. Plus, nearest dealer is 160 miles away.
I think it must have been going slowly for some time, so I can't imagine anything catastrophic happening within a couple of weeks...
How long can I run on it this way without causing further problems? I'm traveling all week and then plan to participate in a group event (highways and twisties, no auto-x or track). Probably 600 planned miles before a window to get it fixed. Plus, nearest dealer is 160 miles away.
I think it must have been going slowly for some time, so I can't imagine anything catastrophic happening within a couple of weeks...
Is there any aftermarket part to replace this with that's not fluid filled or at least doesn't fail quite as easily? I figure while under warranty it's not such a problem but once out of warranty if this fails I only want to have to deal with it once.
2004 build date 04's have the same mount as 05-06.
Mine was replaced once under warranty.
Now that I'm out of warranty and past two years since it was replaced, I'm in the middle of replacing it as I type.
That E12 torx bolt is a PITA!
I stripped the damn thing and had to cut it off (finally).
Btw when I removed the upper bracket, I was able to jiggle the center post of the motor mount freely with almost no force.
The replacement one did not budge by hand. Edit: after installing it it does budge a little bit when rocking the engine.
Part # 22116778610 which I got for $70 shipped from Morristown MINI.
I have to pick up a new bolt tomorrow.
Mine was replaced once under warranty.
Now that I'm out of warranty and past two years since it was replaced, I'm in the middle of replacing it as I type.
That E12 torx bolt is a PITA!
I stripped the damn thing and had to cut it off (finally).Btw when I removed the upper bracket, I was able to jiggle the center post of the motor mount freely with almost no force.
The replacement one did not budge by hand. Edit: after installing it it does budge a little bit when rocking the engine.
Part # 22116778610 which I got for $70 shipped from Morristown MINI.
I have to pick up a new bolt tomorrow.
Just looked, and my 05mcs has fluid in that area. Is there more than one fliud filled motor mount? Is the warranty fix something better or just replacing it with the same questionable part?
thanks.
thanks.



I assume it won't hurt the car to drive it to the dealer