Hey folks!

Though I'm fairly mechanically inclined and have
several mechanics whom I deal with when I feel a job
is "over my head" or when I'm just too lazy to do the job
myself. Blah, blah ,blah...
-I'd feel much more confortable having my Mini's
pulley swapped by someone who has done one before.
Does anyone have a suggestion for an installer in
Central Florida? I don't want to drive to Renntech.
I've dealt with them in the past (had a Renntech CLK)
and they were great. But it's a six hour round trip
from Daytona!

Any suggestions would be greatly appreciated,
- Jim

 

You should have drove down to Renntech when Randy was there. I and a few other from the Tampa area went down, and that's a longer drive than from O-town. Come-on, motor man... motor.

 

I would have if I'd had my Mini then. --I've only had her for a week.


>>You should have drove down to Renntech when Randy was there. I and a few other from the Tampa area went down, and that's a longer drive than from O-town. Come-on, motor man... motor.

 

Bubba,

GREETINGS :smile: !!! Welcome to MCO and the Florida MINI Family.
Congratulations on your recent purchase ! You will definitly improve the driveability and performance of your MCS with the pulley conversion !!
My MCS drives like a different car - and all for the better. Pulling from a dead stop is much easier, and power at the top end is amazing !! You will be glad you did !!!!!!!

Hope to meet you at one of our events !!

Best Regards,
Ron