R56 Brake replacement question

Reply Subscribe

Thread Tools

Search this Thread

Sep 6, 2018 | 03:15 PM

pluffmud

Thread Starter

2nd Gear

Joined: Apr 2016

Posts: 106

Likes: 9

From: Edge of America

Brake replacement question

Searched but couldn't find answer to the question. Have replaced a lot of brakes but have not dealt with the screw in type caliper piston. Is it necessary to get/borrow the tool made for the job or can the piston be turned/screwed down with channel locks or needle nose vice grips?

Thanks.

Sep 6, 2018 | 03:21 PM

pluffmud

Thread Starter

2nd Gear

Joined: Apr 2016

Posts: 106

Likes: 9

From: Edge of America

Never mind, all - found a link. Off to Harbor Freight I go.

Sep 6, 2018 | 09:21 PM

WayMotorWorks

Vendor

iTrader: (10)

Joined: Jul 2006

Posts: 10,621

Likes: 802

From: Atlanta, GA

Yup the Harbor Freight tool will get it done the cheapest.

__________________

Sep 8, 2018 | 09:34 AM

harley0711

5th Gear

Joined: Aug 2007

Posts: 800

Likes: 9

From: Prescott, AZ

What tool did you get? Its been awhile since I did this? About time to do it again

Sep 8, 2018 | 10:07 AM

pluffmud

Thread Starter

2nd Gear

Joined: Apr 2016

Posts: 106

Likes: 9

From: Edge of America

Quote:

Originally Posted by harley0711

What tool did you get? Its been awhile since I did this? About time to do it again

The Harbor Freight one - 44 bucks. Works fine. Unfortunately, discovered the left rear piston rubber all mangled up - stuck the new pads on, buttoned it up, ordering a new caliper.