When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I have a 2008 clubman s I just had a valve job done put everything back together and now im getting two codes one is a 2f1a and the other is a 2f19 which according to what I did fine it had something to do with my temp sensor but I can read engine temp on my modus scanner so any help would be appreciated
you can read temp, but you dont know for sure if it the correct temp...make sure you let the bubbles out of the cooling system. there is also a breather next to the temp sensor, open it a little till the coolant flows out. finally, you might have a faulty thermostat unit!
My check engine light comes on when the outside temp goes above 70 degrees F. It was fine all winter but we had a hot day yesterday and it lit up the dash board. The last time i had it cleared the code seemed to point to a fuel system fault. Any experience with that issue?
I took the car to a repair shop and interestingly they told me there were no error codes. They did say that there were 3 systems on a list of 10 that were not in a ready state.
i couldn't get the codes. Do I take it back and let them put the thing on a more precision machine or do I take it to Mini and ask them to read the codes?
Let autozone check it for you. Clear it and see if it pops again. Mine did the same few weeks ago and said o2 sonsor. I cleared it and nothing back so far!!!
