Hi guys, I need some special help about remaping my MCS.. The thing is that car was already tuned when it had 15% pulley installed, but I have gone with the original one and have been getting code p0107 since then and I can’t get rid of it. I assume it is because the values for map sensor were changed and just want to know for sure if I am not mistaken…
Thank you for your help and have a great day!

 

I'd suggest considering a remote tune performed by forum member @adriancl (in Romania) as a few of us did recently and numerous here and across Europe previously (Adrian says 150+ MINIs by him). Cost is quite reasonable and he is multilingual. You would have to purchase a couple of adapter cables to enable use of INPA and NCSExpert during that remote session, however doing so recalibrated to match the performance mods on my R53 while completely resolving cold start issues related to those mods likely going back to 2006.

BTW, welcome to the forum!

 

^^^ +1 = What he said @adriancl ^^^

 

+2000000 on going through adriancl