Sir Speedy build
#1
Sir Speedy build
I just bought this 2005 MCS with the factory aero kit. It has only 69700 miles on the clock. While it's in great shape there are many toys I plan to buy and install. It came with metal expansion tanks and a jcw exhaust.
so far I've added a black hood scoop and window tint:
I have camber plates and the wmw upper motor mount are waiting for installation.
Next up:
Alta air intake,
15% pulley, Hawk pads
Drilled/slotted rotors,
Steel braided brake lines,
Short shifter,
Rear sway bar.
If anyone has a checkerboard rearview mirror cover for the non-auto dimming rvm they would be willing to sell please IM me.
so far I've added a black hood scoop and window tint:
I have camber plates and the wmw upper motor mount are waiting for installation.
Next up:
Alta air intake,
15% pulley, Hawk pads
Drilled/slotted rotors,
Steel braided brake lines,
Short shifter,
Rear sway bar.
If anyone has a checkerboard rearview mirror cover for the non-auto dimming rvm they would be willing to sell please IM me.
The following users liked this post:
ECSTuning (06-29-2022)
#2
#3
New mounts
2 more mods: WMW solid upper motor mount and the Ireland engineering fixed camber plates/mushrooming blocker.
Question: So I torqued down the bolts too tight on the top strut mounts (the mounts came with no instructions). All but 2 we're fine, but the two that weren't spun freely on the bolts. I was forced to Dremel/chisel them off. The threads on the bolts got a little banged up so when I put new bolts on I added and additional wider washer to both with the hope that it would rise the nut up higher on the bolts where the threads were still good. The new nuts tightened down to the correct torque (18 lbs. It turns out). So, am I ok? See the pic.
Question: So I torqued down the bolts too tight on the top strut mounts (the mounts came with no instructions). All but 2 we're fine, but the two that weren't spun freely on the bolts. I was forced to Dremel/chisel them off. The threads on the bolts got a little banged up so when I put new bolts on I added and additional wider washer to both with the hope that it would rise the nut up higher on the bolts where the threads were still good. The new nuts tightened down to the correct torque (18 lbs. It turns out). So, am I ok? See the pic.
The following users liked this post:
Soul Coughing (07-12-2022)
Thread
Thread Starter
Forum
Replies
Last Post
ej
MINIs & Minis for Sale
2
08-30-2015 02:36 PM
CRRIKEY
MINIs and Minis for Sale (archive)
10
06-16-2008 11:06 PM
Morales
MINIs and Minis for Sale (archive)
15
06-11-2008 08:23 AM