F55/F56 Over boost after hard pipe kit install?
#1
Over boost after hard pipe kit install?
So I've been running an NM Power Module, Eventuri Intake and Forge High Flow Intake for well over a year now. I just put in FTP charge and boost pipe kit last month and now I'm starting to get over boost code and a check engine light. Has anyone else experienced this? Could boost pressure really gone up that much with the pipe kit? I took out the NM module and the check engine light went out the next day after a nice long drive, and to be honest, the butt dyno feels the same with it gone.
I do have a Miltek DP sitting on the bench and then was going to contact Mario for a tune. Will the DP add even that more boost?
I do have a Miltek DP sitting on the bench and then was going to contact Mario for a tune. Will the DP add even that more boost?
The following users liked this post:
bradstyle (06-14-2021)
Thread
Thread Starter
Forum
Replies
Last Post
Drivetrain Boost Tubes - Silicon vs Hardpipe
guitfiddler
Drivetrain (Cooper S)
19
06-08-2009 11:47 AM