How To Trunk lid grip button not working – DIY
#104
I removed the motor and direct wired it to the battery. It worked all 5 times I tried. All the wiring checks out all the way to the plug. Something is wrong from the boot/trunk to wherever it gets power. All the wiring in the rubber sleeve is intact.
Thank you for taking the time to answer this thread.
Thank you for taking the time to answer this thread.
#105
Ok so it's not getting 12 volts... Did you check the relay?
I use a LoadPro which loads the circuit to see if it truly is carrying enough voltage. Any minor corrosion will cause a circuit failure even though it shows continuity.
I use a LoadPro which loads the circuit to see if it truly is carrying enough voltage. Any minor corrosion will cause a circuit failure even though it shows continuity.
I removed the motor and direct wired it to the battery. It worked all 5 times I tried. All the wiring checks out all the way to the plug. Something is wrong from the boot/trunk to wherever it gets power. All the wiring in the rubber sleeve is intact.
Thank you for taking the time to answer this thread.
Thank you for taking the time to answer this thread.
Thread
Thread Starter
Forum
Replies
Last Post
RandyR90S
R56 :: Hatch Talk (2007+)
3
05-14-2014 11:42 AM