2017 Cooper s 5 door. Recently replaced the stock taillights with Euro taillights from ECS tuning. I swapped the little circuit board over, swapped out standard bulbs for LED and installed. Also swapped front turn signal bulbs for LED. Upon coding with Bimmercode, my Angel Eyes no longer come on with parking lights/Daytime running lights but DO work with full headlights.

I have tried restoring with Bimmercode backup but it does not give a list of backups to restore from to go ALL the way back to my initial scan.

Anyone have experience with this and can help out?

thanks in advance.

 

not addressing your specific question, since I don't know, I think that there are two settings for the category angel eyes. one for brightness with low beam, and the other for brightness with parking lights.
I'm just looking at the available f56 settings on bimmercode's site, and haven't verified the availability directly hooked up to mine.
https://bimmercode.app/cars/f56/

there is no off, but goes down to 10 percent.

there is also a category listed on this site for daytime running lights, which can be specified to not active.

you mentioned that you've already done the bimmercode. I assume that you've already seen these, but don't say so, directly. I thought of mention it, then, just in case.