I have a 2004 MCS with a reduction pully installed. (bought it this way).
I am looking at the pully but do not see a name or part number on it. I spoke to the dealer and they said that if it is bolted on, not pressed. It is def not stock.
Now I am wondering what kind of headache i am in for when it comes time to change the belt!

Any Ideas, or solutions?

 

No headache at all. A NAPA 060539 will work on just about every pulley size. If it is a 19%, you can go with a 060535. The other option that always works is the Gates JCW belt from the dealer. The belt tensioner will take up slack on the belt to a point, so it isn't as critical as you may think.

Measure the pulley's diameter, and I can tell you which reduction size it is. If you have a good picture of it, I can probably tell as well.

Hope that helps!
Randy

 

Great! Thank you for the help. I guess I shouldn't have worried so much after all the pully is only 15%, so if you think about it, it's only maybe a 3/4 inch difference, if that?

Im not in need of it yet, but will save this part number.
thanks again

 

With the 15%, either the JCW or the 539 will work great

Randy