Drivetrain Seeking confirmation
Thread Starter
|
2nd Gear
Joined: Mar 2005
Posts: 120
Likes: 0
From: Port Moody, BC, Canada
Seeking confirmation
I've been searching through threads and I think I've got my information straight and I just want some confirmation.
Fact or Fiction?
1) The stock cat-to-resonator pipe on the MCS is 2.25 inches in diameter.
2) The stock header's post-cat outlet is 2.25 inches in diameter.
3) The Milltek header's post-cat outlet is 2.5 inches in diameter.
Without getting into too much detail, I've been looking at picking up a Milltek header and mating it to my stock exhaust (which I will one-ball). If I do this will I cause sufficient heat build-up in the cat to burn it out?
Anyone out there have this combo?
Any input would be greatly appreciated.
Bryan
Fact or Fiction?
1) The stock cat-to-resonator pipe on the MCS is 2.25 inches in diameter.
2) The stock header's post-cat outlet is 2.25 inches in diameter.
3) The Milltek header's post-cat outlet is 2.5 inches in diameter.
Without getting into too much detail, I've been looking at picking up a Milltek header and mating it to my stock exhaust (which I will one-ball). If I do this will I cause sufficient heat build-up in the cat to burn it out?
Anyone out there have this combo?
Any input would be greatly appreciated.
Bryan
Thread
Thread Starter
Forum
Replies
Last Post
Alpha Motoring
MINI Parts for Sale
4
Sep 7, 2020 07:34 PM
Navigation & Audio Installing the PAC SWI-RC Steering Wheel Control Interface
Filmy
Navigation & Audio
6
Jun 28, 2016 08:58 AM
jennster
Stock Problems/Issues
3
Sep 28, 2015 06:19 PM
DevilMeTaz
R60/R61 Stock Problems/Issues
1
Sep 22, 2015 05:19 AM
