Cooper (non S) Modifications specific to the MINI Cooper (R50).

Early 2003 R50 won't start

Thread Tools
 
Search this Thread
 
  #1  
Old 04-13-2012, 08:59 PM
tgfh's Avatar
tgfh
tgfh is offline
Neutral
Thread Starter
Join Date: Feb 2012
Posts: 5
Likes: 0
Received 0 Likes on 0 Posts
Early 2003 R50 won't start

I bought a 2003 R50 and repaired the front quarter. Both Bags deployed - all work done but will not start. Wipers work - lights come on - not even a click at the starter. And yes I bought a new battery. Does the early 2003 (mfr 1/03) have an immobilizer? Checked all grounds again.
Thanks
 
  #2  
Old 04-14-2012, 09:47 AM
ammodave's Avatar
ammodave
ammodave is offline
5th Gear
iTrader: (1)
Join Date: Dec 2008
Location: Niceville Fl
Posts: 915
Likes: 0
Received 18 Likes on 17 Posts
Deleted
 

Last edited by ammodave; 04-14-2012 at 08:22 PM. Reason: Wrong forum
  #3  
Old 04-14-2012, 02:26 PM
UKSUV's Avatar
UKSUV
UKSUV is offline
6th Gear
Join Date: Oct 2004
Location: Marsala, Sicily
Posts: 3,673
Likes: 0
Received 2 Likes on 2 Posts
Yes....there is an EWS unit on the vehicle. You can bypass it if you have to but that is at your own risk. I know nothing....
 
  #4  
Old 05-19-2012, 02:23 PM
valvashon's Avatar
valvashon
valvashon is offline
5th Gear
Join Date: Jun 2009
Location: West Seattle
Posts: 654
Likes: 0
Received 20 Likes on 16 Posts
Check the switch on the clutch master cylinder. I'll add some pictures later, but after rebuilding the starter I was getting the same problem- turn the key to crank and silence. Troubleshooting I should have done before pulling the starter then included checking for 12v and the solenoid terminal when the key is turned. Since there was none, I checked the clutch safety switch and found that it had popped out of position. It looks quite easy to pop off if bumped, so I think that's what happened and I'm not sure I needed a starter rebuild, except for the fact that beating on the bottom of the starter would make it work again.

Maybe there were two problems at once. If the switch seems in position try checking for the 12v at the solenoid terminal. You'll have to figure out where it comes from (the EWS, if I remember) as it is almost impossible to get to without pulling the exhaust manifold and heat shields.

Val
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
sevin
1st Gear
125
02-01-2016 11:30 AM
alistaircookie
R50/R53 :: Hatch Talk (2002-2006)
6
10-08-2015 10:52 AM
Sikness
R57 :: Cabrio Talk (2009+)
4
08-20-2015 06:00 PM
skippermini
1st Gear
6
08-12-2015 10:05 PM
PrimePower
R50/R53 :: Hatch Talk (2002-2006)
10
08-11-2015 12:51 PM



Quick Reply: Early 2003 R50 won't start



All times are GMT -7. The time now is 07:59 AM.