Does anyone have some Dynamat left over from a previous project? I am wanting to do the rear seat delete but have a ton of cabin noise once the seat is taken out.
email me at indy82799@gmail.com
thanks

 

it takes more then some scrap to do a rear seat delete with dynomat. I used a full 3 feet under my sub box. only had enough to do my licence plate.

 

Dynamat comes in different sizes but the original full sheet of Dynamat is 12 square feet (32"x 54")! Plenty to do a couple of cars. If nobody has any extra...does anyone want to split the cost and order a new roll?
http://www.dynamat.com/store/store-car.asp

 

Save yourself a bunch of money and trouble - don't just get Dynamat. It isn't the best, although it is the most expensive.

I just recently did an install (well, to be fair, PGT did 2/3 of the work) in my MINI, using B-Quiet Ultimate, which is as good or better than Dynamat Extreme and a heck of a lot cheaper.

Check out this showdown though - it will give you some insight as to what products are out there and how they compare to Dynamat:

Sound Deadener Showdown

 

I'm actually looking to silence my car as well - is there any thread/website describing how do to do the whole car (boot, floor, door panels, etc.) and the materials to be used ?

Thanks!

 

just a note.. i picked up the $100 door kit at circuit city this week for about 50. not sure if it was a clearance but it was a good deal

 

thanks a bunch!

 

What brand and what was the SKU?

Thanks,

Rich

 

That website says, "Prevent alien mind control while driving!" I knew the aluminum texture was for more than sound deadening.

 

It was said as tongue-in-cheek... I hope you caught that.

 

Rich,
it was the dynamat extreme. It is on their site for 100 but in the store it was marked for 50. They might be discontinuing selling it. I think they had one more package that i am going to pick up.