I am over in the Clemson Anderson area.

Looking for a reputable experienced shop to do a 15 degree pulley install and Tensioner stop (and throw on a new belt while at it) in our area. Before I buy the Alta stuff I need to know that someone can do it locally and whether or not to buy direct or let the get it for me.

Do we have anyone good in the area on these things?

MCSc 2006

 

The folks over at DDMWorks can probably get you set up. Give them a call:

864-907-6004

They're located near Donaldson Center, off I-185 (Southern Connector) and US 25.

 

Sounds good. Any idea the average install rate for something like this? Do they like to use their own obtained things or customer aquirred?

 

Looks like they have their own pulley. Not sure about the Tensioner stop though. I emailed them last night to see whats up.

 

Dave and the group is pretty good at getting back to people, but feel free to call if it takes too long. It's not a big shop so more than likely you'll end up with Dave on the phone.

 

Yea I will call them. But I am baby sitting the Grandbaby today and don't know when and if I could get into a prolonged discussion today without getting interrupted so I figure not a good idea to call today from my end of things.