Hey Todd,

Does anyone make one piece calipers for the rear?

 

1pc caliper? Not sure I follow.

You mean a single function caliper such as a two pot or four pot without the p-brake?

 

I just installed dba drilled/slotted rotors along with ebc yellowstuff pads in the front. I went to the track yesterday and i am VERY happy with the stopping power and 0 brake fade

 

Old survey apparently, but sure!

Went with slotted as I've seen comments here & elsewhere that drilled have a tendency to crack/break.

 

where did you get slotted JCW rotors and how much were they?

 

what I would like...

BIG 15 inch rotors with six piston calipers for the front and 13 inch four piston calipers for the rear. Sold as a kit with Stainless Steel brake lines and optional backing plates that accept cooling duct hoses. (a four wheel kit around $3000.00 with optional backing plates)

With pad and rotor replacements that are inexpensive...(...e.g., $80.00 and $160.00)

Motor on!

 

Doesn't Fred Flintstone already have this sorted ?
ISAMIN

 

Wrong post

 

last post was 2016 dude . . .and THAT comment was to a 2014 . . .

 

Finally have a few sets of our popular FSL calipers IN STOCK for 13" track kits.

That help??