Ok guys... here's what I have going on... bought a 2011 r55 with blown n18... bought a 2013 r56 n18 parts car... swapped motors... wired bosch HPFP correctly per ISTA diagram... sent r56 dme off to get cloned to the r55.... got it back with egs codes, no power, and 4500 rpm limit... deleted learned variants and adaptations as per another NAM thread... now I have no throttle response as if the pedal isn't even there... when letting out on the clutch the engine will rev, once clutch is out it slowly falls, until clutch goes to the floor and comes back up a little then the engine will rev again... i have also done the throttle reset by key in, ign on, hold throttle down for 30 secs, let out on throttle, clutch in, and start car.. no change

What's my next move? how do I resolve this??

Thank you!!