Missing Tranny Bolt?
Missing Tranny Bolt?
Would some one with an 07, manual transmission go look underneath their car. Right near the part of the exhaust with the "wrap" around it, in the center bottom portion of the transmission halves, is there an empty bolt hole? Directly underneath this empty threaded hole his a little bit of yellow paint and a litte green paint.
I was changing the oil today and noticed this. There doesn't seem to be any fluids leaking. It's the area shown in the red circle. A bolt the size of the one directly above/left of the red circle would fit in this.
Thanks!
I was changing the oil today and noticed this. There doesn't seem to be any fluids leaking. It's the area shown in the red circle. A bolt the size of the one directly above/left of the red circle would fit in this.
Thanks!
Last edited by Minidrivr; Jun 10, 2008 at 06:07 PM.
mine is like that too.
when I first brought my mini home it had a bad "oily" leak. I crawled under that car and saw the missing bolt on the tranny and "oily" residue all around it....I assumed that's where the leak was.
long story short the dealer determined I had a rear main seal leak, and the missing tranny bolt wasn't missing and was supposed to be that way.
still doesn't make sense to me why there is an empty bolt whole, but it's supposed to be that way.
when I first brought my mini home it had a bad "oily" leak. I crawled under that car and saw the missing bolt on the tranny and "oily" residue all around it....I assumed that's where the leak was.
long story short the dealer determined I had a rear main seal leak, and the missing tranny bolt wasn't missing and was supposed to be that way.
still doesn't make sense to me why there is an empty bolt whole, but it's supposed to be that way.
Thanks for checking.
Since the engine and tranny is installed at the factory from below, lifted up into the car, maybe this bolt hole is used to bolt it to the chassis they move around in the factory before installation.
Since the engine and tranny is installed at the factory from below, lifted up into the car, maybe this bolt hole is used to bolt it to the chassis they move around in the factory before installation.
please see my post above
Trending Topics
These are for helping you remove parts.
Same as my reply here.
https://www.northamericanmotoring.co...98#post2486498
Same as my reply here.
https://www.northamericanmotoring.co...98#post2486498
Thread
Thread Starter
Forum
Replies
Last Post
patsum
R50/R53 :: Hatch Talk (2002-2006)
26
May 29, 2021 06:29 PM
Mini Mania
Drivetrain Products
0
Sep 3, 2015 10:29 AM







