Hello All!
I need help please... about a month ago I replaced the turbo feed line and the oil filter housing gaskets and since then I have been getting the P0597 with Limp mode. I have replaced the thermostat housing twice now thinking maybe one of them was bad and still getting the same code and limp mode and yes I bleed the system. Im out of ideas.. I have no idea what else it could be. I have read and everything points back to the thermostat housing. Please help.. and thank you!

 

it would help you a lot if you can read the live data of of the coolant temp and status of the thermostat. at least you can see if the temp is functioning properly and the thermostat is not stuck. Also, double check the pipes' routing in case you plugged some in the wrong inlet.

 

I use Torque to monitor and so far it seems normal like it was before all this started. and I did think about the pipes but like I said all this started after I changed out the turbo line oil feed and the oil filter housing gasket. But I will go thru everything again.