R56 Looking for a downpipe any suggestions?
#2
The following users liked this post:
scotty_r56s (05-27-2019)
#3
I suggest a better quality catless one. I bought the cheapest eBay one that although works and fits perfectly isn't the best quality in my opinion. You will need a tune to get rid of the check engine light though. The haters will soon be here to lip off about catless pipes though.
Ty for your time. I think I'm going to go with Mario's downpipe when I can get up the $$$. Seems that going a bit cheap to save some money might not be the best thing to do.
#4
Vendor
iTrader: (10)
I've used both catted and catless. But I personally run an Akrapovic on my Clubman and GP as I like the sound to be muffled slightly with the cat. I had the catless before and it was just a little drone on the highway so I wanted to avoid that.
https://www.waymotorworks.com/akrapo...6-r57-r58.html
But if you want catless I use the Milltek as their new design has the flange and top of the pipe all cast as one part to make it reliable and not a weld on the flange.
https://www.waymotorworks.com/millte...-downpipe.html
https://www.waymotorworks.com/akrapo...6-r57-r58.html
But if you want catless I use the Milltek as their new design has the flange and top of the pipe all cast as one part to make it reliable and not a weld on the flange.
https://www.waymotorworks.com/millte...-downpipe.html
#5
I've used both catted and catless. But I personally run an Akrapovic on my Clubman and GP as I like the sound to be muffled slightly with the cat. I had the catless before and it was just a little drone on the highway so I wanted to avoid that.
https://www.waymotorworks.com/akrapo...6-r57-r58.html
But if you want catless I use the Milltek as their new design has the flange and top of the pipe all cast as one part to make it reliable and not a weld on the flange.
https://www.waymotorworks.com/millte...-downpipe.html
https://www.waymotorworks.com/akrapo...6-r57-r58.html
But if you want catless I use the Milltek as their new design has the flange and top of the pipe all cast as one part to make it reliable and not a weld on the flange.
https://www.waymotorworks.com/millte...-downpipe.html
Ty you. I will try that downpipe to start. That is in my price range
#7
Trending Topics
#8
No Problem, just make sure its the updated version 3, because the previous versions had fitment issues. Heres a link just in case
https://www.cntracing.com/products/c...tless-downpipe
Good luck!
https://www.cntracing.com/products/c...tless-downpipe
Good luck!
#10
Thread
Thread Starter
Forum
Replies
Last Post
Edward Cheng
R58 :: Coupé Talk (2012+)
5
08-26-2017 07:54 AM
my2nds4
Drivetrain (Cooper S)
3
12-16-2013 08:54 AM
Symptom
Drivetrain (Cooper S)
41
10-15-2012 12:23 PM