Hopefully someone here can help me with this. I have an 07 MCS with a JCW intake on it. With this setup, there is a rubber seal that slips over the turbo inlet (air intake side) and the JCW intake pipe slips over this grommet and is tightened down. Mine is split somehow, and now the intake tubing keeps slipping off the turbo inlet. I don't know the part # and can't find where to buy it. Does anyone here know? Thanks so much!

 

I'm not finding it see picture below, best advice would be to either call the dealer or maybe ask Way at WMW to see if he'll sell you one. The dealer may have a call out part # for them.

 

Hi. Usually I see the concern happen when over tighten. Then the car throws a check engine light and runs funny. I would just order a new one from the dealership and install it. You just need a 7mm socket for both clamps.

 

Sorry to revive an old thread but I have the same problem where the rubber piece split. Any one know where to order one?

 

I had the same issue with the split inlet tube....dealer charges $182 plus tax for the part only, so I opted for a CF NM intake for another $150.

 

Finally got help from MiniDeLux on Mini2.

Part is here for anyone else that may need it

http://www.ebay.co.uk/itm/GENUINE-CI...d=470424730185

same part as the peugeot one